FF03行唔到直線問題(己有新進展 48#~)

did u check yr saver is ok or not ,or the problem is come the other way?

levinw 發表於 2011-9-5 21:23

                               
登錄/註冊後可看大圖

did u check yr saver is ok or not ,or the problem is come the other way?

如果唔計係SERVO SAVER既問題.......
仲有個問題係轉向果PART野..........
即係我用手輕輕將個頭轆向車頭方向推上推落果時就覺得轉向果度係
有D虛位.....於是再望真D轉向果度發覺圖中紅箭咀位置係有擺動既現象~
首先唔知關唔關果度事而令架車行唔直.........請師兄過下目先.......
同埋如果我加D介子上去唔知會唔會好D呢???

登錄/註冊後可看大圖

steering post...ne

半年應該is servo saver,anyway add some shim on steering post to fix it first!

if the steering post is damage too much ,then change 3-racing whole set la ,tamiya option post too expensive la...!need 2-3 difference item to complete whole set ar!!!

now u turn on the radio n car (Don't move the CONTROL),then turn the wheel by yr hand ,then u can found where is damage!!!  

if this is come from the steering post ,then the saver will not move by the linkage,if the saver also moving then that is the saver problem la..ok

咁沉晚就已經買左TOP RACING SERVO SAVER
同兩包內直徑分別係3MM同5MM既介子～
而兩包介子亦包含晒0.1MM至0.3MM既厚度～
點解會買介子呢．．．原因小弟始終都係覺得
係轉向果部份有虛位而引致行唔到直線～
咁我就分別係圖1中就每邊攝左5塊5MM內徑0.3MM厚既介子～
而圖2就分別每邊攝左4塊3MM內徑0.2MM厚既介子～

登錄/註冊後可看大圖