FF03行唔到直線問題(己有新進展 48#~)

YR SERVO SAVER IS DAMAGE, CHANGE A "TOP"SERVO SAVER $40 ...

OF CAUSE,THE OTHER ONE IN STEERING SYSTEM CHECK ALL THE BALL CUP IS OLD OR NOT, THE OTHER TWO IN DAMPER ,IS IT MOVING FREE N SAME LENGHT,THE OTHER THREE IN SUSPENSION ARM ,IS IT GO UP N DOWN FREELY,HOW ABOUT THE DOWMSTOP?

MY FF03 PRO IS THE SERVO SAVER DAMAGED, THE TAMIYA ALU-BLUE ONE ALWAYS DAMAGE IN INSIDE.....SO CHECK THIS FIRST!!!

AR ....THE OTHER 4 IS THE ""PIN"" IS DAMAGE OR NOT?

check check check check it up !!!!!
rcracing u said very right!!!!!

FF-03 alway the first problem is servo saver !!!!! check it first !!!!turn the saver by yr figer TRY TRY man

the first time i contact to u is talking this one ...man check it up!!1gogogoggo

don't use tamiya servo saver again laaaa
use "top" laaaaaa

difference level ne...
my FF-03,M-05,M-04,  already change la..

did u check yr saver is ok or not ,or the problem is come the other way?

steering post...ne

半年應該is servo saver,anyway add some shim on steering post to fix it first!

if the steering post is damage too much ,then change 3-racing whole set la ,tamiya option post too expensive la...!need 2-3 difference item to complete whole set ar!!!

now u turn on the radio n car (Don't move the CONTROL),then turn the wheel by yr hand ,then u can found where is damage!!!  

if this is come from the steering post ,then the saver will not move by the linkage,if the saver also moving then that is the saver problem la..ok