車殼開窿一問

唔知大家幫車殼開窿既時候，係由底鑽上面，還是由面鑽落底呢？

Drill from outside the bodyshell to the bottom...

drill from out to in.......mo mut 水口

其實兩面開都無所謂,老實講你唔會一下就鑽到落底.....我自己就會上面開小小.....下面再開小小......開到size為止....個窿一定靘.....
最好買支靘靘開孔器.....包靚.....

原帖由 monkichi0210 於 2006-1-3 07:08 PM 發表
其實兩面開都無所謂,老實講你唔會一下就鑽到落底.....我自己就會上面開小小.....下面再開小小......開到size為止....個窿一定靘.....
最好買支靘靘開孔器.....包靚.....

Agree, drill it from both sides

對呀,兩邊無所謂,最緊要開得準....

Thanks a lot for you guys' experience !!  

點樣先準？

measure the body postad and make a mark with marker pen on the body shell,depend to what car kit you using.....but some body shell have a mark on it,like tamiya and HPI....maybe protoform or proline body shell didn't have mark on it

坊間流傳兩套方法...分別是上色前或上色後用.....
上色前透明殼就當然易對位d...對準車轆位再mark柱位......但要留意左右是否對稱......我自己就好執著...我會用間尺度到準先mark位......而且仲會將車殼柱cut短少少先至mark位....咁當然唔好cut到用唔到.....因為太長的殼柱(多數係後殼柱)會頂住個殼好易mark錯....咁mark通常咁樣都會幾準......

如果個殼已經上o左色....通常會在車殼柱上面....用marker加少少色....然後放個殼上去.....對準位然後大力印一下...個mark就會印在車殼內....可以先度一度是分左右對稱.....就可以開窿........

嘩......好長氣......thx!!!

monkichi0210 發表於 2006-1-5 19:18
坊間流傳兩套方法...分別是上色前或上色後用.....
上色前透明殼就當然易對位d...對準車轆位再mark柱位..... ...

師兄謝謝詳細分享