RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

 找回密碼
 新玩家註冊
搜索
查看: 1760|回復: 16
打印 上一主題 下一主題
收起左側

新手第一次玩油車,買了車,入了油,但...

  [複製鏈接]
跳轉到指定樓層
1#
煋人 發表於 2012-3-22 22:33:11 | 只看該作者 回帖獎勵 |倒序瀏覽 |閱讀模式

遊客登錄

您需要 登錄 才可以下載或查看,沒有帳號?新玩家註冊

x
開不到車,不太識用火咀
2#
 樓主| 煋人 發表於 2012-3-22 22:37:06 | 只看該作者
火咀有的
有無師兄師姐
幫下小弟
3#
@肥基@ 發表於 2012-3-22 23:02:05 | 只看該作者
火咀有冇插電呀
4#
rico 發表於 2012-3-22 23:23:17 | 只看該作者
唔識睇下付近有無師兄幫下你。
5#
asaq-wong 發表於 2012-3-22 23:37:15 | 只看該作者
邊區呀? 樓主~
6#
asaq-wong 發表於 2012-3-22 23:39:58 | 只看該作者
手撻定電撻? 乜野車?
7#
pkogps 發表於 2012-3-22 23:43:22 | 只看該作者
師兄買了邊款?
8#
bear_cat_x 發表於 2012-3-23 08:33:14 | 只看該作者
回復 煋人 的帖子

ching,
1. put fuel into fuel tank
2. plug the exhaust outlet by using finger or toilet paper
3. pull the engine repeatedly until fuel is going into the engine
4. remove the plug mentioned in 2. above
5. put the glow starter on the "dick" at the heat sink. (do you know how to put?)
6. pull the engine. if fuel has already get into engine and glow starter has been installed properly, you can smell burnt fuel. it means the engine tends to start. give it few more pulls, it will then start!
9#
bear_cat_x 發表於 2012-3-23 08:35:16 | 只看該作者
回復 煋人 的帖子

ching, after you have started your car properly, can we play together sin?
10#
cedricho 發表於 2012-3-23 12:25:03 | 只看該作者
回復 煋人 的帖子

咩區?
11#
bear_cat_x 發表於 2012-3-23 13:00:38 | 只看該作者
tsing yi?
12#
 樓主| 煋人 發表於 2012-3-23 23:55:09 | 只看該作者
上水,弄了一天
着了車,但又很快熄了
和如果 我玩完了,不知如何才可熄車呢?
13#
rcworldhk 發表於 2012-3-23 23:58:18 | 只看該作者
14#
bear_cat_x 發表於 2012-3-24 08:42:58 | 只看該作者
回復 煋人 的帖子

to shut down the engine, you can:
1. squeeze the fuel inlet; or
2. plug the air inlet; or
3. plug the exhaust outlet.
there may be many possibilities that your engine stops immediately after it started. even low battery level of the glow started is also a reason. properly charge your glow starter and retry. if problem subsists, try to adjust the main needle by using following stupid but sure method:
1. rotate the needle by 180 degree clockwise;
2. make sure fuel has got into engine;
3. install glow starter and pull start;
4. if not ok, then remove glow starter and rotate the needle anticlockwise by 180+180 and then 2, 3. if not ok, then remove glow starter and rotate the needle clockwise 180+180+180 and then 2, 3. if not ok, remove glow starter and rotate the needle anticlosewise 180+180+180+180 and then 2, 3... and so on until the engine starts properly.
15#
kay1926 發表於 2012-3-24 09:10:29 | 只看該作者
C HING 是不是住上水,明天來粉嶺火車站我幫你 SET - SET ,大家研究下,你玩 OFF ROAD ,  定 ON ROAD
16#
DOG007 發表於 2012-4-3 22:55:37 | 只看該作者
入場玩啦...我以前都係入場得到好多熱心既師兄幫手
17#
jack326 發表於 2012-5-8 21:30:43 | 只看該作者
新手報到
您需要登錄後才可以回帖 登錄 | 新玩家註冊

本版積分規則

手機版|小黑屋|RC EVOLUTION - 遙控工房

GMT+8, 2024-4-27 20:36 , Processed in 0.077513 second(s), 16 queries , Gzip On.

Powered by Discuz! X3.2

© 2001-2013 Comsenz Inc.

快速回復 返回頂部 返回列表