艱苦經歷.......TT01-M(FINISHED #2)

艱苦經歷.......TT01-M

DAY ONE:
original frp chassis is too soft
hand made a 2mm Alum. chassis..........
TO BE CONTINUE

if i use m03 萬向 @ TT01 - M, do i need to change the 前後杯 to metal parts,or i can use originla 前後杯? thx c hing
DAY 2:
hand made main shaft
build up the chassis

咁辛苦呀…師兄，如果照抄，買套板好過

3# chacha
haha   DIY ma

用手鋸定積梳

5# chacha
積梳,c hing, can u answere me the question in #2??
thx

樓主嘅心幾另人佩服 !

不過比我就, 一係 等碳纖板出, 一係就買多塊底板, 一齊裝當加硬 !

just an advice!  your aluminium sheet will not able to take impact, as those are not heat treated aluminium, will twist and band easily, strongly suggest you  use stronger upper deck.

Original TT  f/r up rights are ok, if you got spares bucks, good way to buy aluminium f/r up rights.
appreciate your post, I m also using alu sheet for off my buggie under trade protections.

精神可嘉！不過鋁板一撞就曲，C hing 要有心理準備。

ps 令我想起我第一架遙控車 - 林宝 Countach LP 500.....
http://oldtamiya.interfree.it/models/58008.htm

hard work

不要介意，因我覺得有法國大餐感覺

嘩...好大功程呀.

if i use m03 萬向 @ TT01 - M, do i need to change the 前後杯 to metal parts,or i can use originla 前後杯? thx c hing
koji1230 發表於 2009-6-4 02:10

                               
登錄/註冊後可看大圖

要轉金屬parts......建議連差速齒都換埋其他touring的牙差齒，咁就可以用普通o既金屬差速杯連接萬向。

This is a very good idea , I do almost for all my cars .....   except Buggy!

11# 清清
haha,i'm in holiday,just make some DIY
may be it's no use ga

This is a very good idea , I do almost for all my cars .....   except Buggy!
raymen 發表於 2009-6-4 16:32

                               
登錄/註冊後可看大圖

還以為C兄改油車，2層板咪好重

可能師諗住可以散埋熱呢

要轉金屬parts......建議連差速齒都換埋其他touring的牙差齒，咁就可以用普通o既金屬差速杯連接萬向。
smallfaifai 發表於 2009-6-4 15:41

                               
登錄/註冊後可看大圖

then the cost to make the TT01M is very expensive wor!

18# powis
agree
i use original 差速齒 ja
i don't want put much $ in this car
not worth!

可能師諗住可以散埋熱呢
chacha 發表於 2009-6-4 21:54

                               
登錄/註冊後可看大圖

i think it will "cup" 熱 ......
haha