How to set 2.4G fail safe?????

各位bro.
我買咗2.4G for my M11,
Is that there is a fail safe function can it be set??
If so can any brother teach me how to set(step by step)
Thanks!!!

which one .. spektrum or sanwa 2.4 ?

原帖由 kawada 於 2008-1-21 13:12 發表

                               
登錄/註冊後可看大圖

which one .. spektrum or sanwa 2.4 ?

It's a spektrum
thx!!!

1.a For Micro rx ;  plug in the binding plug & power on ( the orange LED will then start blinking ) keep the bindling plug on
1.b For 3000/3001 type rx ; press the binding button & power on ( the orange LED will then start blinking ) and release the binding button

2. Switch on the Tx by pressing the spetrum setup button and Hold the throttle to the brake position ( keep holding it ); the orange LED should start blinking then release the tx spektrum button
3. Both Tx & Rx LED will become solid after couple of seconds
4. Now, release the braking position of the tx
5. Pull out the binding plug of ur mirco Rx ( nothing to do with the non pro one )

Your system is now binded, u may then switch off the tx power to check the fail safe function

[ 本帖最後由 kawada 於 2008-1-23 10:13 編輯 ]

Manual here
for 3000 or 3001 rx
http://www.spektrumrc.com/ProdIn ... structions_v5p1.pdf
Micro Rx
http://www.spektrumrc.com/ProdIn ... nd_Instructions.pdf

原帖由 kawada 於 2008-1-21 14:18 發表

                               
登錄/註冊後可看大圖

1.a For normal rx ;  plug in the binding plug & power on ( the orange LED will then start blinking ) keep the bindling plug on
1.b For micro type rx ; press the binding button & power on ( the orang ...

多謝曬你