DT-02 MS

原帖由 li5115 於 2007-12-26 00:58 發表

                               
登錄/註冊後可看大圖

避震 有改短嗎？

Hi Leo Hing.

all original.

原帖由 go2usie 於 2007-12-26 00:48 發表

                               
登錄/註冊後可看大圖

joe , does it still available in any shop ?

when did u bought that ?

Hey man, if i remember well you have one T.losi which is rear power wor. take that to play/race with Mr Ryan, me

yes i will ~~ i will fix it in these few days~~!

TKO 2WD party~~

Your Car is very Beautiful!!!
After received the bonus from last Friday, I want to buy this car...
Finally...I buy Nintendo WII...
So no money to buy now la

i think a bonus should be enough for both DT02MS and Wii ~~

Yes... Can affort both...
But I need to control myself...because I have invest many money on my lazer! :'(

louis, Lazer is 4WD, DT is 2WD .... it is different , it is reasonable to buy a different type of buggy for play ...

i ve made u an excuse.... :lol

原帖由 louischow 於 2007-12-26 03:16 發表

                               
登錄/註冊後可看大圖

Yes... Can affort both...
But I need to control myself...because I have invest many money on my lazer! :'(

you can take all electronic parts to your new DT02 wor . don't play wil wor, all bros must take you back
to TKO:lol   :lol :lol

原帖由 recargo 於 2007-12-25 18:16 發表

                               
登錄/註冊後可看大圖

1.aluminum motor heat sink
2.ball differential.
3.universal shaft.
4.large dish wheels.
5.hi-torque servo saver.
6.beautiful sticker

All plastic parts the same as DT-02 ?

我都諗緊買唔買 ...
我睇說明書D縲絲直接上落A-arm 個pin hold 度
個位係最受力，會唔會好容易爆？
以前玩媽星回力鏢就係因為咁 D A-arm 容易爆。
最後要DIY A-arm pin + E-ring 先解決倒。

joe and ryan~ what type of motor will u use~ ?

原帖由 go2usie 於 2007-12-26 18:41 發表

                               
登錄/註冊後可看大圖

joe and ryan~ what type of motor will u use~ ?

I use black pig. To me, and for a 2WD, a black pig is already very fast, faster than a 23T 4WD.

原帖由 rk2 於 2007-12-26 12:25 發表

                               
登錄/註冊後可看大圖

All plastic parts the same as DT-02 ?

Yes

thanks ryan~
i will put a 540VZ motor to try try~
i m not sure how many turn it is .... it is came from Avante

joe~ i know your car is new and powerful with full option~~ for fair play ~u are not allow to use moter less then 23T~~

原帖由 go2usie 於 2007-12-26 23:53 發表

                               
登錄/註冊後可看大圖

thanks ryan~
i will put a 540VZ motor to try try~
i m not sure how many turn it is .... it is came from Avante

540VZ
Usable voltage: 7,2V - 8,4V
Torque at best efficiency: 430g-cm (7,2V)
R.P.M. at best efficiency: 19.000rpm (7,2V)
Current drain at best efficiency: 14A (7,2V)
Best efficiency: 81% (7,2V)
Turns: 21 single - 0,8mm

[ 本帖最後由 li5115 於 2007-12-27 02:32 編輯 ]

oh~ thanks Leo~~~

i do an unfair play tim...........   it is 21 turn....

since it can be work with 101bk esc... i thought that were over 25T ...

原帖由 go2usie 於 2007-12-26 23:57 發表

                               
登錄/註冊後可看大圖

joe~ i know your car is new and powerful with full option~~ for fair play ~u are not allow to use moter less then 23T~~

no worry, i have one black pig equipped.

原帖由 go2usie 於 2007-12-27 00:27 發表

                               
登錄/註冊後可看大圖

oh~ thanks Leo~~~

i do an unfair play tim...........   it is 21 turn....

since it can be work with 101bk esc... i thought that were over 25T ...

21 turn ?? but your one is long time ago. I do not scare

原帖由 recargo 於 2007-12-27 01:16 發表

                               
登錄/註冊後可看大圖

21 turn ?? but your one is long time ago. I do not scare

This 540VZ was a 1986's product. it's 19,000rpm only but high torque.
Compare with today's 23T TZ or BZ(over 25,000rmp), it still a bit slow.
If this 540Vz in good condition, it must faster than the SportTuned(18,500rpm and 350g-cm).

My DT-02 fits with a BZ 23T.

[ 本帖最後由 li5115 於 2007-12-27 02:35 編輯 ]