想請問...linear & pulse 放電不同之處？

when & why using linear & pulse??

THX all brothers!!

When:
Use Pulse 30A to discharge the battery to 0.9-1.0V first
then Linear discharge (equalize) to 0.6-0.7V , then immediately charge it again

Why:
Pulse for better and faster discharging , and linear for equalizing the voltage before charging it again

Good to know this! Thanks.

[ 本帖最後由 batcat 於 2007-11-2 00:27 編輯 ]

Thx for the simple & clear advise
Do you know Trinity DPD can do that??

原帖由 SpidermanRC 於 2007-11-1 08:40 發表

                               
登錄/註冊後可看大圖

Thx for the simple & clear advise
Do you know Trinity DPD can do that??

From the site
"Discharges and conditions 4 or 6 cell side by side packs. Discharges 4 or 6 cell stick packs with external leads. 30 A Dyna Pulse™ discharge. 5 A linear discharge. Adjustable: Cut off voltage, Number of cells, 4 or 6 cell internal, 4 to 9 cell external, Pulse or linear discharge, Internal or external charging modes. Displays individual cell and total pack results, discharge time, average voltage, internal resistance, mAh. Superior battery clamping system for positive contact. No power supply needed; runs off AA batteries."

So yes, it can

wa tks so much
good info