新手MA-020S DRIFT 問題

silvia_s13 發表於 2017-2-3 11:26
應該係,長響仲要轉向轉埋一邊最盡,會卡實左
想問部車有冇得RESET?
THANKS

有得reset的.


To reset KT19 transmitter:
(1) Turn off the transmitter if it is on.
(2) Make sure that the steering trim knob is at the center position
(3) Turn the G.SPD L knob fully to the counterclockwise direction.  ( 逆時針方向 )
(4) Position of G.SPD H knob does not matter.
(5) Turn the steering wheel to the fully right position and push the throttle away to the full-brake position and hold them.
(6) Turn on the transmitter. The LED should flash rapidly; this means you are now in the factory mode.
(7) Release the steering wheel and throttle lever.
(8) Turn the steering wheel fully to the left, right, left and right, and then release it.
(9) Pull/push the throttle lever to full-throttle, full-brake, full-throttle, and full-brake, and then release it.
(10) Turn the G.SPD L knob to the right most position. The LED should become solid.
(11) Turn off the transmitter and on it again. You are done.

Sonny_Crockett 發表於 2017-2-3 18:08
我果兩部ma020s 只是改了摩打heat sink, 金钃直軸和gyro, 雖然比mr03慢了許多, 但是用來玩甩尾已經夠玩了;  ...

師兄，其實而家出咗咁多車，雖然性能屸真係無可比擬，但我始終都係鐘意玩番京商車，可唔可以講下， MA-020有邊啲件係比較容易老化，需要定期更換的?

因為我近來發覺架車跑唔直，但又搵唔到咩原因

現時換咗軚尺，前底蓋，servo arm，servo齒都無乜幫助

Sonny_Crockett 發表於 2017-2-3 21:55
有得reset的.

我已經RESET左,但都係唔得
要揾第二支控試先知車定控有問題
慘

civicwong 發表於 2017-2-4 00:47
師兄，其實而家出咗咁多車，雖然性能屸真係無可比擬，但我始終都係鐘意玩番京商車，可唔可以講下， MA-02 ...

我都係偏愛玩Kyosho的蚊車, 至於ma020有邊啲件係比較容易老化，需要定期更換的問題我着實不知; 正如我所講兩部ma020s是用來觀賞多過玩的, 只玩了3到 4 pack電左右, 未發現此車有甚麼弱點; 另外, 十二年前的ma010由於車價實在太貴並沒有玩過, 所以四驅mini z來講我是新丁, 但可以好肯定說傳動組件損耗會比後驅車快很多, 就算將來差速掃了牙我也不會考慮用珠叉, 單向或直濕, 仍然會用番走牙差速.

Mini z 有一個共通的弱點, 就是每每在碰撞後走不了直線, 要透過微調修正, 所以玩的時候要避免碰撞; 不過遙控模型車的物料強度已非常高, 如果換轉是真車, 三兩十公里撞一撞修車費都好驚人了.

silvia_s13 發表於 2017-2-4 04:14
我已經RESET左,但都係唔得
要揾第二支控試先知車定控有問題
慘

只玩了兩三次就壞了兼且reset都唔得就着實耐人尋味些少.

Sonny_Crockett 發表於 2017-2-4 09:00
只玩了兩三次就壞了兼且reset都唔得就着實耐人尋味些少.

好神奇
今日攞左去模型舖話架車塊板死左要睇下有冇貨換
之後返屋企我再試多一次
一開又冇事
真係估佢唔到
唔洗再買多架