RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

 找回密碼
 新玩家註冊
搜索
樓主: wmej1
打印 上一主題 下一主題
收起左側

Losi SCTE 分享

    [複製鏈接]
81#
22年 發表於 2011-10-3 10:17:42 | 只看該作者

我用左邊哩把,都係打大約 2 到 2.5 mm 直徑窿窿。普通五金店有售幾十元有交易非常方便。


82#
Marksman 發表於 2011-10-3 10:18:36 | 只看該作者
Can we just by a metal tube (like taken from some extendable antenna the end pole) and punch it by hammer?
83#
Marco明 發表於 2011-10-3 10:19:44 | 只看該作者
euro614 發表於 2011-10-3 10:11
洗呔方法要改?點改?
我習慣一定洗呔...

係呔面開孔.......你一洗d水咪入哂去個膽度......
我就未試過所以唔知d水對個膽有咩影響......亦都唔會試囉.....我覺得耐用度一定會降低
仲有.....d水入左去......入面所有塵都立即'痴'實哂........我覺得就係咁喇
84#
Marco明 發表於 2011-10-3 10:25:18 | 只看該作者
euro614 發表於 2011-10-3 10:14
我都想越細越好,但睇來睇去開孔果d機都好大個,就算係開錶帶果d都係,Co哥買咩機來開?
我而家開殼器整 ...

我用cutter only~~~
用新既刀片(美術用果d cutter)......界個細3角形......攪掂
最方便當然係22兄所講既開孔器
85#
euro614 發表於 2011-10-3 10:31:37 | 只看該作者
Marco明 發表於 2011-10-3 10:25
我用cutter only~~~
用新既刀片(美術用果d cutter)......界個細3角形......攪掂
最方便當然係22兄所講 ...

我cut唔穿
其實我想學buggy呔咁,在其中一粒釘邊開半,又走氣,又唔入水
86#
Marco明 發表於 2011-10-3 10:33:45 | 只看該作者
euro614 發表於 2011-10-3 10:31
我cut唔穿
其實我想學buggy呔咁,在其中一粒釘邊開半,又走氣,又唔入水

唔明......
其實sc呔同buggy呔有咩分別
87#
euro614 發表於 2011-10-3 10:38:55 | 只看該作者
Marco明 發表於 2011-10-3 10:33
唔明......
其實sc呔同buggy呔有咩分別

我意思係唔打穿成個孔,只係沿著粒釘邊(界)開一半,活塞作用。
88#
Marco明 發表於 2011-10-3 10:42:40 | 只看該作者
euro614 發表於 2011-10-3 10:38
我意思係唔打穿成個孔,只係沿著粒釘邊(界)開一半,活塞作用。

哦......都可以一試......咁sc呔都一樣得架
不過我覺得效率可能會減半.........anyway, no fixed rule
89#
euro614 發表於 2011-10-3 11:01:00 | 只看該作者
本帖最後由 euro614 於 2011-10-3 19:20 編輯

其實玩車仔都有好多小學問,小常識,真係唔試,唔問,唔會知..
但厘d學問,永遠都唔會有人在forum問or提出黎,真係要落場見到人地點整,先知點做..

回想初初玩buggy,唔知要穿呔孔,玩一陣就甩..
sorry 打錯字,係穿呔孔
90#
Marksman 發表於 2011-10-3 11:06:20 | 只看該作者
Marco明 發表於 2011-10-3 10:19
係呔面開孔.......你一洗d水咪入哂去個膽度......
我就未試過所以唔知d水對個膽有咩影響......亦都唔會試 ...

I tried last week and the tire finally trashed!

Running in rainly day the tire foam fully abosrbed with water, I clean it and squeeze out the water and play again, repeated several times last 2 days in MX, finally one of the tire have the foam inside broken and being pushed to one side inside the rubber, can't be fixed anyway.

For running in wet I think we need corresponding wheel type, sealed etc.
91#
Marco明 發表於 2011-10-3 11:15:10 | 只看該作者
本帖最後由 Marco明 於 2011-10-3 11:16 編輯
Marksman 發表於 2011-10-3 11:06
I tried last week and the tire finally trashed!

Running in rainly day the tire foam fully abosr ...


So.....don't wash it if not fully sealed
92#
Marco明 發表於 2011-10-3 11:25:09 | 只看該作者
回復 Marco明 的帖子

re : euro614  所以Co哥永遠唔玩濕泥..  

一來啦......二來d泥撻實左d釘......根本唔好跑
洗又麻煩......又唔好跑......so玩少陣好過
93#
Marksman 發表於 2011-10-3 11:39:24 | 只看該作者
回復 Marco明 的帖子

Thats true, the soft mud is totally losing traction, more the power and weight of the car, more slide and slip, no fun and energy waste.

I also found the motor temperature raise from 60C normal to 90C max. when running in the wet mud, also much shorter running time on the same battery, the water suck by the 4 wheels and the mud stick on the car body made the car total weight nearly 50% heavier!
94#
fr888 發表於 2011-10-3 13:12:11 | 只看該作者
本帖最後由 fr888 於 2011-10-3 13:20 編輯
Marco明 發表於 2011-10-3 09:23
盡量係呔面開孔(特別係mx呢d咁鬆散既場)......跟手封實隻鈴原本有既孔
如果係鈴度開會入哂沙即場報廢
...

禾會用水洗呔, 所以情原用D soft D既膽.......
95#
MR.TAMIYA 發表於 2011-10-14 23:17:28 | 只看該作者
明天Mx club-
losi gogogo!!!!!!!!!!!
96#
oscarchoi 發表於 2011-10-21 23:35:44 | 只看該作者
Thank wmej1
97#
 樓主| wmej1 發表於 2011-10-23 20:54:58 | 只看該作者
Here is my some upgarded parts and hope the below information can help who want to order those parts. Enjoy it.

Chassis: Original 281g, TLR4000 211g
Center Bulkhead: Original 8g, OP 17g
Center HD Lightened outdrives: Original 11g, OP 8g
Fr/R HD Lightened outdrives: Original 7, OP 5g
Front Shock Tower: Original 13g, OP 10g
Rear Shock Tower: Original 13g, OP 10g
Rear Hub: Original 6g, OP 9g
Losi Adjustable Front Hinge Pin Holder Set
Losi Adjustable Rear Hinge Pin Holder Set
Aluminum Front Chassis Brace: Original 8g, OP12g
Aluminum Rear Chassis Brace: Original 6g, OP10g

                               
登錄/註冊後可看大圖


                               
登錄/註冊後可看大圖


                               
登錄/註冊後可看大圖


                               
登錄/註冊後可看大圖


                               
登錄/註冊後可看大圖


                               
登錄/註冊後可看大圖


                               
登錄/註冊後可看大圖


                               
登錄/註冊後可看大圖


                               
登錄/註冊後可看大圖


                               
登錄/註冊後可看大圖


                               
登錄/註冊後可看大圖


                               
登錄/註冊後可看大圖


                               
登錄/註冊後可看大圖


                               
登錄/註冊後可看大圖


                               
登錄/註冊後可看大圖


                               
登錄/註冊後可看大圖
98#
alanwhc 發表於 2011-10-23 21:33:58 | 只看該作者
勁有心机,Good!
99#
 樓主| wmej1 發表於 2011-10-23 22:03:55 | 只看該作者
i wont go to sheung shui to race this car again as when i rebuild this car, WTF of the mud or {banned} from that track, really dont understand how they maintenance their nice track, extremely disappointed of them. You can found a big stones on the track to hurt of car.
100#
 樓主| wmej1 發表於 2011-10-23 22:47:39 | 只看該作者
China track
您需要登錄後才可以回帖 登錄 | 新玩家註冊

本版積分規則

手機版|小黑屋|RC EVOLUTION - 遙控工房

GMT+8, 2024-5-27 07:10 , Processed in 0.067344 second(s), 17 queries , Gzip On.

Powered by Discuz! X3.2

© 2001-2013 Comsenz Inc.

快速回復 返回頂部 返回列表