Dismantling the Engine Cylinder & Inner Head

Just  disassemble the engine for checking.
Find the Cylinder, shim & Inner Head are held firmly and cannot separate.
Any c-hing can share the experience for dismantling these.
Thanks in advance!

Yes, just right about overheating and operate for ling time.
Bearing will worn out, head oring sleeve all stuck together.

Just  disassemble the engine for checking.
Find the Cylinder, shim & Inner Head are held firmly and ...
st_kuen 發表於 2010-9-22 00:45

                               
登錄/註冊後可看大圖

use a heat gun or hair dryer to heat the crankcase first.

回復 1# st_kuen


黎TRC我話俾你知

回復  st_kuen


黎TRC我話俾你知
chungtsai 發表於 2010-9-22 16:24

                               
登錄/註冊後可看大圖

yes.

回復 4# chungtsai


TRC's c-hings are always helpful to freshman!
Especially those guys in the container which located at the corner!

I was pushed to the corner of the container.