[求助]Art tech只predator點轉receiver?

如圖所示,架機得兩個servo,V tail機,兩個控制面only.
有趣既係得一舊9.6v電池供電,經電變比電receiver同時有接收信號控制motor.
我用只fataba receiver,插channel 2&4 set v-tail無問題.
但係就控制唔倒個motor,無反應......
應該點做?
多謝解答~!

測試 ch3 , ch3插上 servo, 動作是否正常, 如不正常, ch3 可能有問題
否則 esc 可能出問題, 睇 esc manual set 油門高低點

Use Channel 3.

Like Andrew168 said, if still not working, try reverse Channel 3 in the Tx.

Default CH3 is1 FUTABA Thuttle
Try CH3 for your ESC Connection , If thuttle RANGE IS OVER TRY GIVE 100% THUTTLE and connect the battary the lowest the thuttle again to set the Thuttle range

用servo試過channel3無問題.

ESC係指mud野?
全稱係......

electric supple control

electric supple control
coltm16 發表於 2009-5-30 21:39

                               
登錄/註冊後可看大圖

成本manual search唔倒有electric supply control呢只字眼

可以較得既係曬度......
邊個搞throttle?

等高手答完先

都無人答,我只是唔識想學野

ESC = electronic speed controller (電變).  EPA- ch3, push throttle stick up and set it to 100%, then push it to lowest postion and set it to 100% again.  sorry don't have art tech so not sure how to set it up.....  Is it right zifu?

hi throttle timer high
low throttle timer low
and after than set middle