how to make 尾直濕

i am using tt01d type E

thx for your sharing

哦~~~   好似明左d...
^^"

回復 17# patrickli071

無差速 means: both left and right wheels will rotate at the same rate. it's because both wheels are attached by a solid axle.

There are lots of articles here:
RC EVOLUTION - 遙控工房 » 電車技術討論版 » 電車技術討論精華文章
http://bbs.rc-evo.com/forumdisplay.php?fid=43

無差速係咪即係你踩油佢先轉, 一唔踩就會即刻停咁既意思呢??
^^"  真係好多野問...

CHING們, 咁有時見d 人要改"頭直", 又係為左咩原因呢?
改裝方法又如"尾直"一樣嗎?
1524 發表於 2010-8-21 01:44

                               
登錄/註冊後可看大圖

頭直 -> 快車用多,因頭直可以遲D剎車及不打白鴿轉.
改裝方法又如"尾直"一樣嗎? -> Yes for TT01

快車多數: 頭直尾叉
漂移: 頭單尾直/頭珠尾直/頭牙尾直/頭直尾直 (玩法不同)

CHING們, 咁有時見d 人要改"頭直", 又係為左咩原因呢?
改裝方法又如"尾直"一樣嗎?

回復 12# patrickli071

用尾直濕不是令兩個胎冇動力。是希望後輪無叉速，導致甩尾(漂移) 效果。

玩drift掛,tt01d bo
椰禮 發表於 2010-8-21 00:17

                               
登錄/註冊後可看大圖

係bor...睇漏左個 d  

新手問一句~
尾直濕: 係咪即係後面果兩個碌唔會有動力呀??

轉貼舊post,如果係牙差既話

                               
登錄/註冊後可看大圖

黃色係個內籠,灰色係Y牙,紅色係細傘齒,藍色係大傘齒

回復 6# hardmankam


    Thanks a lot.  Its really great solution. tks

請問點解要將尾差速轉行直濕?
1524 發表於 2010-8-20 23:35

                               
登錄/註冊後可看大圖

    玩drift掛,tt01d bo

請問點解要將尾差速轉行直濕?

Thanks, was going to buy a solid shaft...this is way better and cheaper.

Another way is to cut 2 matching sticky rings and place them between the diff plate and the gear.  Do not use the diff balls.  Then tighten as much as possible.  (see photo ... taken http://www.drccentral.com/forums ... opic=10175&st=0)

登錄/註冊後可看大圖

Tight the screw as much as possible.  

But changing a ball diff to a spool is NOT the best idea since the diff balls will dent the diff plates.

C HING
想問珠差 正 直濕 點攪好?   謝謝

冇錯,塞紙巾落去就OK,不過最好加小小泥膠,如寶貼萬用膠,咁會更耐用

cheapest way: stick tissue paper into the gear.