TT-02 玩家討論區

YSL 發表於 2013-7-23 23:51
今日改少少先

C hing, change the plastic center shaft la

I have been using a HW 60A 13.5T. The plastic center shaft seemed OK so far but I already broke a front knuckle, a rear C hub, a steering joint and deformed a crome plated rim so far. No direct full speed crashes, just occasional bumps. So I think the TT02 plastic parts are quite fragile. Now I tried to reduce their brittleness by puuting them into boling water and let it cool before using.

今日改少少先

A Ching runs 4t with full turbo in jv. One gear broke after 4 pack lipo

Anyone run a fast motor in this car ? e.g. 7.5T with turbo or 5.5 T (no turbo) ??

Wondering if the car can handle it

hungbobby 發表於 2013-7-22 23:27
feel the TT-02 ride height not low enough despite set low ride height. i stick a small piece of magi ...

Any photo of where the placed the "magic tape" ?  Thanks.

02好D……

kkchung 發表於 2013-7-23 01:13
Acrive Hobby 開始有些競技形改裝。
http://blog.active-online.shop-pro.jp

改晒手腳.......... 但會唔會闊左用唔到190mm殼??

Acrive Hobby 開始有些競技形改裝。
http://blog.active-online.shop-pro.jp

                               
登錄/註冊後可看大圖

                               
登錄/註冊後可看大圖

feel the TT-02 ride height not low enough despite set low ride height. i stick a small piece of magic tape on both rear downstop. on the front i inverted part A8. that shud futher lowet the ride height by 3-4mm

我就係係另一個ching手上買左個凈架, 架車一D都唔難砌, 跟原裝砌無需特別工具

想問下呢架車難唔難砌?? 有冇話要咩 TOOLS??

今日我諗住去出車!!

請問水車跑街边隻呔好？

Karate 發表於 2013-7-19 17:09
TT02 好似暫時全部都有殼跟喎

二手淨架咪冇殼囉

請問你們覺得01 或 02 好啲。

maxkam 發表於 2013-7-19 17:59
丅丅02尾杯可唔可以同TTO1共用？

不能

丅丅02尾杯可唔可以同TTO1共用？

TT02 好似暫時全部都有殼跟喎

小弟剛整好架, 都係打算玩水車, 但除啤呤外, 零option咁濟, 殼都未諗到買邊個

請問TT02 RTR版,KWS邊間最平?