標題: 想買09 問有什麼要改GAR ??? [打印本頁] 作者: RICHOME2 時間: 2008-9-28 10:45 標題: 想買09 問有什麼要改GAR ??? TKS作者: billychan 時間: 2008-9-29 11:59
原庄已經好夠玩，壞了才改啦！作者: donaldt 時間: 2008-9-30 14:01
原庄好好玩作者: donaldt 時間: 2008-9-30 14:04
but probably after a few runs,
you will want:
Chamber
High Speed Gear
Pipe
Light Shaft
Carbon Fiber upper deck(plastic is really too soft)
then of course carbon fiber lower plate (for good look)
metal bulk head front and rear
engine mod
brake
high travel rear hub
the list can go on and on...
the mod will probably costs twice as much as the car作者: billlkyy 時間: 2008-9-30 22:21
咁又要支幾嘢啦.......作者: donaldt 時間: 2008-10-1 02:23
Spada 09 = 18xx
2 servos = 1000 (about)
assume you already have remotes, receiver, and tools
you can run the car for about 3k and be quite happy
but then you want to be even happier, the happier formula is:
(most Prices are not sure)
Chamber = 2xx?
High Speed Gear = 1xx?
wheel shaft (not dog bone) = 18x
Pipe = 5xx?
Light Shaft = 1xx
Carbon Fiber upper deck = 3xx
then of course carbon fiber lower plate = 3xx
metal bulk head front mid rear = 6xx
metal turning hub = 25x
engine mod = depends, but can cost over 500
brake = 2xx?
high travel rear hub = 1xx?
metal carrying cage = about 100
long throttle arm = 4x
so the little extra happiness costs about 4k, about 150% of the car costs...作者: donaldt 時間: 2008-10-1 02:30
I think can classified like this
Level 1 (most needed and cost efficient)
- high speed gear
-1 degree chamber
- light weight center shaft
Level 2 (very useful but cost some money)
- Pipe
Level 3 (still very useful but cost quite a lot)
- Full Carbon Fiber
- Engine Mod
Level 4 (useful, but not very cost efficient)
- Full Metal
- High Travel Hubs
Level 5 (almost useless)
- metal carrying bar
- light weight brake
etc...作者: RICHOME2 時間: 2008-10-1 15:49
WA....要好好考慮
TKS
(for good look)
