RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: Scamper Crash on Maiden Voyage@@ [打印本頁]

作者: bobpinpin 時間: 2008-6-11 12:35
標題: Scamper Crash on Maiden Voyage@@
Got a chance to test this new boat , but it suddenly turned to the right...
Really sad...and I lost the upper part for my graupner boat...

I would replace the esky gyro and test it again..

http://hk.youtube.com/watch?v=N6G4Zu2G1LE

Bob

作者: Badman916 時間: 2008-6-11 13:33
Wa! it's fast.

作者: ten10 時間: 2008-6-11 13:53
ching 請問你用幾 cell 電, 我架 scamper 用 4 cell, 快就快, 不過好嘈

作者: bobpinpin 時間: 2008-6-11 17:26
brother...i m using 11.1 V 3 cell 2200

....my boat is so slow

.....and my original ESC was burnt....Iam still studying the boat..

作者: ten10 時間: 2008-6-12 12:51

原帖由 bobpinpin 於 2008-6-11 17:26 發表

 登錄/註冊後可看大圖

brother...i m using 11.1 V 3 cell 2200 ....my boat is so slow .....and my original ESC was burnt....Iam still studying the boat..

燒電變係咪因為入水?
我架Scamper 就玩咗3 次,發覺有幾個問題
1. 船倉勁易入水,一定要膠紙密風
2. 條裙勁易入水
3. servo 位設計唔惦
4. 陸地玩收油時會磨底
5. 安装條裙比死更難受

作者: bobpinpin 時間: 2008-6-12 18:26
燒電變係咪因為入水?
The original ESC was burnt due to the new DX6i(stj wrong with throttle lowest position), it is not the problem of the ESC itself i believe.

我架Scamper 就玩3 次,發覺有幾個問題
1. 船倉勁易入水,一定要膠紙密風
I dont use plastic tape, I just let the water get in. I wrap the ESC and the reciever with rubber.
2. 條裙勁易入水
Yes, and when you play and without pouring the water out from the 裙, the CG will shift and the boat will go very slow.
3. servo 位設計唔惦
I dont know about it..just leave it there...
4. 陸地玩收油時會磨底
For me , I never play it on ground because I dont want it to be scratched and become worn out.
5. 安條裙比死更難受
I dont want to install and detach it because the design is bad! Even the 裙 is not fit..i just leave it there.

I believe there should be a gathering for all of us to share the tips for installation and way of playing.

bob

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://www.rc-evo.com/xbbs/)