標題: 關於silverback接收電 [打印本頁] 作者: monsterken 時間: 2011-9-17 09:38 標題: 關於silverback接收電 師兄們,我早幾日係kws買左舊silverback既接收電(Li-Fe電),我本來想駁落支GT3B個接收到黎推Savox 既1256,貪佢夠大力,但我尋晚先知原來舊電可以去到6.6V(仲未計佢叉爆可以去到幾多),而隻接收同埋啲(三隻)servo 上限都係6V,請問師兄們咁樣高左0.6V有冇問題呢??我驚一”隊”就因為過左依少少電壓就”林”晒成抽電子晒....麻煩咁多位指教!!作者: TheWolf 時間: 2011-9-17 10:40
just sharing my recent experience, I used a 深水埗鴨記電子牛改頭直叉1600mh 5cell 電到7v, 接s3003 & YR servo flysky 接收無問題. 亦發覺電壓很快降至6.x range.作者: TheWolf 時間: 2011-9-17 10:42
ps. 上久, 用6v 叉不到電, 我是用9v 叉的。作者: bigbigpan 時間: 2011-9-17 11:32
我都係用呢舊接收電, 冇乜問題, 如果驚既咪加外置 BEC 穏壓囉~ 作者: TheWolf 時間: 2011-9-17 12:43
我的電子牛註明max 450mA 第一次當然要留意溫度, 叉足8小時牛和電池也是冷冰冰, 但電池去到7v, ok la. 牛價只若45雞!作者: jf813 時間: 2011-9-17 13:00
I use Life with sanwa rx, normal futaba (9451 and bls451) servo no issue. FS with savox not sure.... But it should be ok too. BTW: do not change the LiFe in LiPo mode..... Must switch to LiFe mode. Cutoff voltage is different.作者: hec 時間: 2011-9-17 14:16
網上有D資料講係break-in階段就唔好放電到低過33%或2.5V, 建議break-in要cycle 20次作者: TheWolf 時間: 2011-9-19 17:32
Sorry for confusing some of you in my previous post, I'm using 5 cell Nimh battery, not Life nor Lipo, my apology. Btw, before my using 9V to charge, I did use multimeter to check my another charger the voltage much higher than the battery's (and get some info from web about Nimh/Nicd quick/slow charging approach), so it should be a 'safe' experience to go ahead.作者: icemen 時間: 2011-9-29 14:06
thx