1/5 gasoline engine can't start

I just run 200 ml of gasoline in my smartech 23 cc engine and suddenly the engine slow down and dead.
I check the plug. And it still look good.  
What else I need to check to troubleshoot the engine problem??
I check the engine stop wiring it is connect properly.  
If the engine overheating what is the symptom.

Thanks

Peter

2衝程?有無在電油中混入2T?

Have I added 2 t in petrol. 1/25 of 2t

Did you close the choke?

回復 Peter966 的帖子

Unscrew the plug, with the cord connected let the plug touch the engine block and pull the starter.  You should see sparks jumping across the gap.

回復 Peter966 的帖子

The smartech cy 23 engine is know to blow the gasket between the cylinder head and the crank case.  You should check that too.  You can get it at radar model and it is very cheap.  I think it is only 17hkd or something......  And another thing you should check is the 2T you are using.....  Friend of mine use cheap 2t and it keep blocking the carb........  

Nope I didn't close the choke. When I close the engine stall. So I leave it open all the while.
After few run the engine slow down and dead.
I will check the plug and gasket tonight. Thanks

Btw the choke need to be close?  It is open just for starting the engine??
I leave the choke open after the engine started. Should close the choke?

The 2 t I use motorcycle 2 t for mixture. Is it ok?

回復 Peter966 的帖子

normal motorcycle 2t should be ok.  the choke is only used during startup to suck fuel into the carb.  If you close the choke the engine will stall.  If everything is ok try to return the L or H to factory setting.  Should be around 1.5 turn open for both.  This setting normally should be quite rich.  Hope you get it sorted.    For the choke operation you can refer to the link below pt3.  

http://fgmodellsport.com/FG-Inte ... Tips-engines_e.html

It the engine is overheated it will not have much power....  and die.  But unlike .21 or .12 engine.  These engine is not likely to over heat as there is a fan inside.  And I had tried to lean the HSN so much so the engine will run very slow and still do not die or overheat.

Thanks.  

The spark plug tested. It fire some spark when the pullstart is pulled while the plug body touched the engine body. So means the plug is ok.
And I reset the HS and LS  to 1.5 turn both. And will test the car next week.

Thanks for all the help.  

most likely is the gasket, change it should be fine

Where to get the gasket?  Any known shop selling smartech 23 cc engine gasket?  
How to tell the shop keeper which gasket is it?

Totally clueless for 1/5 engines gasket.

Thanks in advance.

Radar model at kung tong have it.

http://www.zenoah.net/ddoc/ZENO/ ... ENO2009_AAen_G230RC,G260RC_.pdf

pg 12, part number 2  (Zenoah pn.  848-ER0-97Z0)

But last time i go there their pn is different.  Don't worry.  Just ask them to show you their explode view diagram and look for the same part.

Oh i see. Thank you very much.
That help alot.  
See the engine explode view sooo complicated. Hahahahha