KO EX1 Mars with Futaba MCR 控制問題

Dear all,
MY bike is using Futaba MCR as a ESC and receiver, BUT now the problem comes out.. coz  the MCR come with only one receiver crystal..no transmitter crystal come along.

So i changed to Kyosho miniz transmitter and receiver crystal. Now when turn on transmitter and receiver... the receiver only detect the steering...no any response from the throttle....

can anyone help me how to set up the connection between transmitter and receiver ?????...i am using Ko propo EXI Mars as my transmitter...

or i need to use its original crystal and buy a trasmitter crystal from KWS???

thx all

[ 本帖最後由 kevinchanky 於 2006-7-13 10:19 編輯 ]

我都有同樣事情發生過，但我用的是KO EX1 Mars R，當我用AM module是無法控制的，但我換回普通的futaba控就無問題，原來發現KO EX1 Mars R 是無法對應的，所以我換三件頭來玩，效果令我滿意！

原帖由 chingwingtat 於 2006-7-12 18:51 發表
我都有同樣事情發生過，但我用的是KO EX1 Mars R，當我用AM module是無法控制的，但我換回普通的futaba控就無問題，原來發現KO EX1 Mars R 是無法對應的，所以我換三件頭來玩，效果令我滿意！

THX, So if I still use KO EX1 Mars AM module, but dont use kyosho crystal and use futaba crystal, is it ok?? coz I can control the steering but no response on throttle

[ 本帖最後由 kevinchanky 於 2006-7-13 10:17 編輯 ]

i use mars Ex1 FM module with Mc230R... receiver is Jeti... works fine.
when i put in AM module...  works with the R211J futaba rx..  just kyosho mini Z crystal. and futaba crystal.. both working fine.
the all in one rx and throttle control... not sure about it...

我用緊NOVAK SPY電變、KO 302接收、EX-1 Mars R控，線性好靚！

I using  Mars too, miniz RX,TX cystal and 230esc, no problem found~

Hi every brother!which motoor are you use it omn the bike?