RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

 找回密碼
 新玩家註冊
搜索
查看: 2455|回復: 7
收起左側

用B6差NiMH電問題~

[複製鏈接]
dsds 發表於 2012-6-15 00:42:50 | 顯示全部樓層 |閱讀模式

遊客登錄

您需要 登錄 才可以下載或查看,沒有帳號?新玩家註冊

x
小弟有幾粒白色SANYO白色1900mAH既電芯,
想問下各位師兄如果用B6差電機差佢地應該用咩seting?
因為我試過用1A差,大約半小時佢地就叉完而且會超熱!
所以想向各位請教一下,謝謝!
yipd 發表於 2012-6-15 11:21:35 | 顯示全部樓層
正常因為快差一定會發熱
ray2011 發表於 2012-6-15 12:52:00 | 顯示全部樓層
回復 dsds 的帖子

加風扇吹
 樓主| dsds 發表於 2012-6-15 12:57:08 | 顯示全部樓層
但係差完又好快用完,有冇得正常差?
TigerI2010 發表於 2012-6-15 13:51:55 | 顯示全部樓層
用探温線一起差,過熱時自動降低電流差。
不過我都祇用0.4A電流差。
gta 發表於 2012-6-15 14:00:22 | 顯示全部樓層
本帖最後由 gta 於 2012-6-15 14:03 編輯

回復 TigerI2010 的帖子

所有電太大a數差排電會短命
gta 發表於 2012-6-15 14:06:20 | 顯示全部樓層
回復 TigerI2010 的帖子

經常高a數差死得仲快
bear_cat_x 發表於 2012-7-6 01:34:57 | 顯示全部樓層
Ching, if you set charging current of 1a for a 1900 battery, charging period shall be at least 1.9 hours. Complete charging for less than this showing there must be some problems in your battery such as it has not been properly discharged before being charged. May I ask you what is the designated voltage of your battery and the charging voltage shown in the b6 when charging is nearly completed.
您需要登錄後才可以回帖 登錄 | 新玩家註冊

本版積分規則

手機版|小黑屋|RC EVOLUTION - 遙控工房

GMT+8, 2024-3-29 08:58 , Processed in 0.033974 second(s), 16 queries , Gzip On.

Powered by Discuz! X3.2

© 2001-2013 Comsenz Inc.

快速回復 返回頂部 返回列表