用 4Pk 第3個channel 整跳燈 得唔得!?!?

小弟有支 4PK, Ch1 和 Ch2 已分別駁上 轉向Servo 和 電子變速器.
我想加多隻 servo 系 Ch3個位用來整跳燈,

小弟唔明既地方系:

枝4PK 可唔可以 Set到按一粒制(箭咀呢粒!?), Ch3個Servo就會即刻郁到個指定地方(開跳燈). 再按一下就收番跳燈?? 同埋點樣Set??

登錄/註冊後可看大圖

My concept is from 3PKS, hope is the same setting,

first of all, you need to know what is the name of this botton, like DT1 or DL1, if you can confirm the name.

Go to menu and look for the FUNC-SEL-Dial, then select the correct name of this botton and set it to channel 3.   
I hope its the same setting of 3pks!!
Good luck!

箭咀呢粒 --> 說明書話叫 PS3

原帖由 chappi 於 2009-1-9 23:57 發表

                               
登錄/註冊後可看大圖

箭咀呢粒 --> 說明書話叫 PS3

Good, then go to menu, look for FUNC-SEL-DIAL,
search for PS3 and set to channel 3. check check la!!

我睇說明書話(1)系PS3,可以用FUNC-SEL-SWITCH去設定,而(2)系DL3,用你所講既FUNC-SEL-DIAL來設定.
PS3系一個"咁"制; 而DL3系一個"另"制.
如師兄咁講去set PS3粒"咁"制, 我點樣Set佢既轉覆? 系咪要用DL3粒"另"制??

登錄/註冊後可看大圖

OK, when you set the FUN-SEL-DIAL, you need to set to 2 position, that is to control the servo travel!!

小弟用緊Futaba d入門控
想upgreat個控
問師兄4pk控大約幾錢到呢??
唔該師兄

3k

原帖由 zachary 於 2009-1-14 01:29 發表

                               
登錄/註冊後可看大圖

3k

thank you
咁行2.4G 請問師兄有冇心水推介呢?