Xray T2 009 前臂唔順

請問有冇師兄幫到手?

小弟砌部Xray T2 009 前A臂好唔順.....
已用鎚仔輕輕敲過前A臂及臂 mount, 都係唔順.....

講清楚:
如果張前A臂翻起時, 佢唔會跌返落去就停左呢個位, 好似咁 ----> \ ____ /
後臂完全冇事, 翻起時, 佢識跌返落去好似咁 ----> _ ____ _

Hudy果個 Arm Reamer 又未到手, 仲有冇其他方法? 唔該晒.

請問有冇師兄幫到手?

小弟砌部Xray T2 009 前A臂好唔順.....
已用鎚仔輕輕敲過前A臂及臂 mount, 都係唔順.....

講清楚:
如果張前A臂翻起時, 佢唔會跌返落去就停左呢個位, 好似咁 ----> \ ____ /
後臂完全冇 ...
awth 發表於 11/7/2009 11:04

                               
登錄/註冊後可看大圖

用Arm Reamer 啦....................

2# lung1

Hudy果個 Arm Reamer 又未到手, 仲有冇其他方法? 唔該晒.

2# lung1

Hudy果個 Arm Reamer 又未到手, 仲有冇其他方法? 唔該晒.
awth 發表於 11/7/2009 11:12

                               
登錄/註冊後可看大圖

我諗用Arm Reamer 係最好....用鑽咀有好大可能鑽大左個holes....

2# lung1

Hudy果個 Arm Reamer 又未到手, 仲有冇其他方法? 唔該晒.
awth 發表於 2009-7-11 11:12

                               
登錄/註冊後可看大圖

仲有其他牌子都有Arm Reamer呀，唔一定要用Hudy呀，我都係用EDS啦！
ok o家！

my method....use 3mm pin and some grounding gease......

use 鑽 to hold the 3mm pin with grounding grease.......and then insert the pin into the a arm and switch on the 鑽.......let it rotate untill its smooth....

but again use Arm Reamer is the best method

plastic slim change to alu slim, must be better.

after use Arm Reamer

I using EDS is fine wor... ;-)

Thank you all C-Hing, problem solved~!
Will take some pic and post after 100% assemble.