RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

 找回密碼
 新玩家註冊
搜索
查看: 2704|回復: 12
打印 上一主題 下一主題
收起左側

Shell for TA05VDF

[複製鏈接]
跳轉到指定樓層
1#
gimsink 發表於 2010-7-27 16:05:10 | 顯示全部樓層 回帖獎勵 |倒序瀏覽 |閱讀模式

遊客登錄

您需要 登錄 才可以下載或查看,沒有帳號?新玩家註冊

x
chings pls help :
1/. 190 or 200mm shell is suitable for TA05VDF ?
2/. 24 or 26mm tire width is suitable ??
3/. any offset is required ???
I check every page of the manual but it has nothing mention about this....
2#
 樓主| gimsink 發表於 2010-7-27 19:17:05 | 顯示全部樓層


Drift car no need too fast, I use Hobbywing 35A/8.5T, servo not buy yet, no time...
3#
 樓主| gimsink 發表於 2010-7-27 19:24:38 | 顯示全部樓層
190mm
26mm maybe better
no off set on 190mm
i use sp v3 13.5t and sp pro stock esc,
align ds610  ...
hhxhkuroro 發表於 2010-7-27 18:47


ching, I find a very serious issue, the rear belt very easy to fall off the belt tensioner's bearing if motor run full speed, (see photo below), do you have the same problem ?
4#
 樓主| gimsink 發表於 2010-7-28 09:06:22 | 顯示全部樓層
ching this is good suggestion, but where can I find 有邊bearing ??
5#
 樓主| gimsink 發表於 2010-8-12 10:46:26 | 顯示全部樓層
ching, I tell you la, buying bearing in KWS is not smart, there are some place in MK that you can buy bearing much cheaper (and more choice on brand and quality). Don't give silly suggestion la 金牌會員 !
您需要登錄後才可以回帖 登錄 | 新玩家註冊

本版積分規則

手機版|小黑屋|RC EVOLUTION - 遙控工房

GMT+8, 2025-7-20 03:58 , Processed in 0.121566 second(s), 19 queries , Gzip On.

Powered by Discuz! X3.2

© 2001-2013 Comsenz Inc.

快速回復 返回頂部 返回列表