想買控？PCM??2.4G??/HSR???

Futaba 2.4GHz receiver " FS603FS" , 只support PPM 同 HRS, 用唔到PCM, 若用analog servo 又迫住用PPM. 奱左用唔到fail save /battery save(因為ppm唔support),

咁, 若外加個fail save 會唔唔support 到 2.4G? (有post 話.因為2.4G高頻令外加fail save 失準, e.g Q.xxx).. 還是只有轉用digital servo 行HRS mode 才可以?

thanks r 師兄.

原帖由 ftbingobingo 於 2008-1-18 18:13 發表

                               
登錄/註冊後可看大圖

Futaba  2.4G can use fail-safe on PPM, but need to be set every time turn on

係喎.PPM 要在個receiver 按 SW button. ... ..每次開機set 1 次...  
咁我即係冇得set ...因為個receiver 收得太入了... . 唯有等有錢至用HRS..


"我個人應為玩車係應該差full電,唔係玩玩下(冇差)靠住個fail-safe~" 差電當然la. 我次次都有差足..可惜我舊接收只得AAA 700 x5 ..唔多夠.

thanks r 師兄