MR-03 問題

1) MMS 好多人玩, 基本上大部份都係 03
2) NO fet 用 AD 無問題, 好多人都係咁
3) Gyro 好少人用.

多口問句,800mah師兄有冇親身購入或使用過gyro??
d.s 發表於 2010-2-23 01:01

                               
登錄/註冊後可看大圖

有呀~　借人地o既黎用

tried it on dNano, feels great, helped a lot in preventing the car from loosing control.

but i always prefer hard-setup the car, rather than soft-setup

ARTR Set with body $998
3Racing ball diff $98 (comes with non-magnetic shaft)
Motor mount & Disc Damper >> go for PN racing
T plate >> ATM 7.5mm "blue" t-plate $35
motor gear >> just use original, better tha metal.
Fast motor >> ATM AD stock ($16X @ MMS)

you will also need:
stainless king pin ball >> PN racing $40
spring set (short) >> PN racing $55

有否試過用於MR03??
d.s 發表於 2010-2-23 22:49

                               
登錄/註冊後可看大圖

just say whatever u want about a gyro instead of keep on asking.

i used gyro for a while, i found going straight is definitely not a problem, but turning is shxxxt, how can i rectify it ??? thx...
natnatbobo 發表於 2010-2-24 00:26

                               
登錄/註冊後可看大圖

you can adjust the gyro response, lower it through the ICS

then u can setup the car again to run fast, turn fast, then lower the gyro response again...

until you don't need the gyro anymore.

12# 800mah

c Hing, which part in the ICS ??? lower the figure at ST gain ???
natnatbobo 發表於 2010-2-24 00:37

                               
登錄/註冊後可看大圖

the last two.
one slows down the car while the other auto steers.

14# 800mah

thx C Hing, that means lower the "ST gain" will turn better and add the value at "TH gain" will make the car faster, right ???
natnatbobo 發表於 2010-2-24 00:54

                               
登錄/註冊後可看大圖

one is how much the will auto steer in order to correct "mistakes" sensed by the gyro
the other one is how much the car will slow down during the above auto steer

both work together, if there's no need to auto steer, the car will not slow down