RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: NT-1 Clutch problem [打印本頁]

作者: donaldt 時間: 2008-9-3 19:48
標題: NT-1 Clutch problem
Hello
My NT-1 (yellow clutch) revs to very high before the clutch even engage
and it almost has no low rec...
is it time for a new clutch or is it a setting problem?

Thanks!!!

作者: stanley_wwy 時間: 2008-9-3 20:58
標題: 回復 1# 的帖子
is the clutch spring preload too high?

作者: donaldt 時間: 2008-9-3 21:13
do i need to take the whole clutch out and re-install?
i bought it used and re-assembled the whole car
i followed the manual and set the clutch bell to have some space(manual says 0.9mm but i couldnt measure)

does the 2-speed clutch have anything to do with this problem?
cos i might have let it too loose...

作者: stanley_wwy 時間: 2008-9-4 10:25
標題: 回復 3# 的帖子
seems like you need to find a c hing close to you to help you set the clutch once and learn learn......

where do you live ar? see any c hing can help....

作者: donaldt 時間: 2008-9-5 02:25

原帖由 stanley_wwy 於 2008-9-4 10:25 發表

 登錄/註冊後可看大圖

seems like you need to find a c hing close to you to help you set the clutch once and learn learn......

where do you live ar? see any c hing can help....

Thanks C Hing
went to study the menu and I think I understand the idea now
got a red clutch and some shim, the clutch bell space is minimized now(i think about 0.1mm..)
and i reseted the preload of the spring to about 2 turns and will start it there...
will test it this wekeend

and I want to know is the sound of Nova Turbo Engine different than usual engine?
because my engine seems to have a very high tone
but the compression is not bad( a bit hard to turn the flywheel with fingers)
is there a problem??

作者: stanley_wwy 時間: 2008-9-5 12:29
標題: 回復 5# 的帖子
高音咪堅囉...

正常高轉果時係高音架喎..

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://www.rc-evo.com/xbbs/)