RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: Question on DF-03MS [打印本頁]

作者: tux 時間: 2008-7-13 23:39
標題: Question on DF-03MS
Hi:

I bought a DF-03MS. When I attached the gear case cover part M8 (this cover is used on DF-03 as well - it is to allow adding Slipper Clutch set) to M7 it was very loose - M8 kept dropping off.

Please advise how I can fasten M8 onto M7?

Thanks!

作者: li5115 時間: 2008-7-14 01:10
You need push and turn.

作者: tux 時間: 2008-7-14 10:30

原帖由 li5115 於 2008-7-14 01:10 發表

 登錄/註冊後可看大圖

You need push and turn.

I was aware there were little humps in the inner part of M7. I did try to push and turn M8 but could not get the latch on M8 to slide over the little humps. What else can I do?

作者: li5115 時間: 2008-7-14 10:50

原帖由 tux 於 2008-7-14 10:30 發表

 登錄/註冊後可看大圖

I was aware there were little humps in the inner part of M7. I did try to push and turn M8 but could not get the latch on M8 to slide over the little humps. What else can I do?

Any inside view photo of M7?

作者: tux 時間: 2008-7-14 12:00

原帖由 li5115 於 2008-7-14 10:50 發表

 登錄/註冊後可看大圖

Any inside view photo of M7?

I am busy today - will try to take some photo of M7 later tonight. It may be difficult to show the humps on the photos because M7 is black in colour ...

作者: tux 時間: 2008-7-15 21:59

原帖由 tux 於 2008-7-14 12:00 發表

 登錄/註冊後可看大圖

I am busy today - will try to take some photo of M7 later tonight. It may be difficult to show the humps on the photos because M7 is black in colour ...

I got the Topcad Gear Case Cover and used the original M8 and it worked. (Could not use the metal replacement of M8 - doesn't fit

)

作者: edmondhk 時間: 2008-7-17 00:03
DF-03MS幾錢?

作者: tux 時間: 2008-7-17 00:11

原帖由 edmondhk 於 2008-7-17 00:03 發表

 登錄/註冊後可看大圖

DF-03MS幾錢?

$1,xxx

作者: edmondhk 時間: 2008-7-17 19:03

原帖由 tux 於 2008-7-17 00:11 發表

 登錄/註冊後可看大圖

$1,xxx

1001~1999?

作者: spoonbb6 時間: 2008-7-17 23:36

原帖由 edmondhk 於 2008-7-17 19:03 發表

 登錄/註冊後可看大圖

1001~1999?

under 1500

作者: tux 時間: 2008-7-18 00:12

原帖由 edmondhk 於 2008-7-17 19:03 發表

 登錄/註冊後可看大圖

1001~1999?

$1,4xx

作者: hihizaza 時間: 2008-7-18 09:22

原帖由 spoonbb6 於 2008-7-17 23:36 發表

 登錄/註冊後可看大圖

under 1500

13XX-14XX

作者: edmondhk 時間: 2008-7-19 22:46
thx all

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://www.rc-evo.com/xbbs/)