RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: 玩完一次油車洗唔洗做d咩保養? [打印本頁]

作者: edmondhk    時間: 2008-6-10 18:53
標題: 玩完一次油車洗唔洗做d咩保養?
玩完一次油車洗唔洗做d咩保養?
作者: rotarygod    時間: 2008-6-10 20:19
我最少都會滴幾滴after run oil入副偈
如果玩咗幾次就要check吓d鏍絲有冇鬆
作者: chr    時間: 2008-6-10 20:33
掃走d塵抹走d油屎,滴d after run oil
作者: edmondhk    時間: 2008-6-10 22:08
原帖由 chr 於 2008-6-10 20:33 發表
掃走d塵抹走d油屎,滴d after run oil

滴幾滴after run oil入副偈就可以?
咁都唔算大煩
仲諗住要打散副偈洗tim
作者: leeho888    時間: 2008-6-10 22:48
原帖由 edmondhk 於 2008-6-10 22:08 發表

滴幾滴after run oil入副偈就可以?
咁都唔算大煩
仲諗住要打散副偈洗tim


如果玩咗幾十次我都會打散副偈洗
作者: c.k    時間: 2008-6-11 02:48
玩完一次pyc的話我都會打散副偈 慢慢係到清潔...
作者: blee    時間: 2008-6-12 00:10
原帖由 c.k 於 2008-6-11 02:48 發表
玩完一次pyc的話我都會打散副偈 慢慢係到清潔...


For 打散副偈 every time, your engine will be 打柴 very soon.

Below maintanence is good enough:
Add after run oil into the engine and "dry start" the engine on the starter box (make engine turn, not fire up). Then open the rear cover and use cotton web to absorb those dirty oil........ Eventually, put the rear cover back and add new after run oil again..... COMPLETE.
作者: siriochow    時間: 2008-6-12 03:45
標題: 回復 6# 的帖子
Blee 兄講得岩啊,次次係咁成副打散好打柴,因你張個sleeve蚊出蚊入個機殼口徑好快加大,同你當初溫偈時活塞 sleeve 雞比 架冷以經互相磨合好個位,如果次次成副打散D位就次次唔同,咁你副偈D口徑就大晒好快玩完。
作者: blee    時間: 2008-6-12 06:14
原帖由 siriochow 於 2008-6-12 03:45 發表
Blee 兄講得岩啊,次次係咁成副打散好打柴,因你張個sleeve蚊出蚊入個機殼口徑好快加大,同你當初溫偈時活塞 sleeve 雞比 架冷以經互相磨合好個位,如果次次成副打散D位就次次唔同,咁你副偈D口徑就大晒好快玩完。



Thank you for chinese input.
作者: cpkd    時間: 2008-6-12 10:35
原帖由 blee 於 2008-6-12 00:10 發表


For 打散副偈 every time, your engine will be 打柴 very soon.

Below maintanence is good enough:
Add after run oil into the engine and "dry start" the engine on the starter box (make engine tur ...


It's a good point! So, when should I change the parts inside the engine such as crankshaft, bearing and conrod etc...
作者: blee    時間: 2008-6-12 10:55
原帖由 cpkd 於 2008-6-12 10:35 發表


It's a good point! So, when should I change the parts inside the engine such as crankshaft, bearing and conrod etc...



Until you found your engine performance come down significantly.




歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://www.rc-evo.com/xbbs/) Powered by Discuz! X3.2