RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: Voltage Regulator / BEC [打印本頁]

作者: sunfffd    時間: 2008-3-18 01:38
標題: Voltage Regulator / BEC
I just ordered a the novak crawler ESC
however it just supports up to 7 cells (8.4v max)

But I got some 9.6v battery packs which I dont want to rewire.
Can I use a BEC as a voltage regulator to lower the output from the battery pack?
Any recommendation?
作者: rk2    時間: 2008-3-18 09:02
你要改用support 9.6v 的 esc 較好喎.
作者: edison    時間: 2008-3-18 09:22
I suggest you add heat sink before using 9.6V.
作者: sunfffd    時間: 2008-3-18 09:47
原帖由 rk2 於 2008-3-18 09:02 發表
你要改用support 9.6v 的 esc 較好喎.


但係我已經訂左了
作者: sunfffd    時間: 2008-3-18 09:48
原帖由 edison 於 2008-3-18 09:22 發表
I suggest you add heat sink before using 9.6V.


where should I add it?
作者: edison    時間: 2008-3-18 13:05
Take off the shrink-wrap and then direct attectch the heat sink on the regulator IC (using RAM heat sink). final using shrink wrap to repack it.




歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://www.rc-evo.com/xbbs/) Powered by Discuz! X3.2