RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: Engine 130度,OK嗎? [打印本頁]

作者: lcn    時間: 2007-12-31 17:25
標題: Engine 130度,OK嗎?
Engine 130度,OK嗎?
12仔engine.好多人都唔好超過110度,真的嗎?
作者: stanley_wwy    時間: 2007-12-31 17:36
標題: 回復 1# 的帖子
12仔 engine 130度??? 

你定係想講十二級engine 呀?

如果你係講spada 副原廠sirio, 咁就真係好熱 

[ 本帖最後由 stanley_wwy 於 2007-12-31 17:38 編輯 ]
作者: piccoengine    時間: 2007-12-31 17:37
standard temp around 110~
作者: stanley_wwy    時間: 2007-12-31 17:40
標題: 回復 1# 的帖子
睇下你用咩engine 同咩pipe 啦....

有d pipe 係會熱少少...

同埋睇你副野run 好未....未溫好又會熱d.

如果你副野係要130度先夠快, 又唔會追油, 又穩定o既話, 又唔係嗌到想死, 咁都勉強okay o既...唔通放到慢先玩咩, 鬥車時更加理得佢死 

如果你係夾硬lean 到 130 度, 又唔快又追油....咁就好快死....

不過正常玩都係 100-120 度倒.

同埋, 你個body shell 有冇開散熱洞呀?

[ 本帖最後由 stanley_wwy 於 2007-12-31 17:43 編輯 ]
作者: henry888    時間: 2007-12-31 17:56
我都想請教下, 我run副12仔既engine, 得5x-6x度
係咪正常?依家行左10缸油左右
作者: lcn    時間: 2007-12-31 18:29
標題: 回復 4# 的帖子
唔該晒stanley_wwy .
body shell 有開散熱洞.係OS 12級.
冇追油,又穩定,o甘即係ok?
作者: stanley_wwy    時間: 2007-12-31 20:00
標題: 回復 6# 的帖子
12TZ?

咩pipe?
作者: stanley_wwy    時間: 2007-12-31 20:02
原帖由 henry888 於 2007-12-31 17:56 發表
我都想請教下, 我run副12仔既engine, 得5x-6x度
係咪正常?依家行左10缸油左右


正常....熱少少都得, 七十零度都可以...

睇下你lean 落去快唔快囉....唔快就六十零度okay......呢架車仔...唔駛咁快啦, 過吓癮啫
作者: henry888    時間: 2008-1-1 07:43
原帖由 stanley_wwy 於 2007-12-31 20:02 發表


正常....熱少少都得, 七十零度都可以...

睇下你lean 落去快唔快囉....唔快就六十零度okay......呢架車仔...唔駛咁快啦, 過吓癮啫


thx very much bro~
my fd teach me if i want the engine to be durable, i shouldnt lean it during run-in period and just after run-in peroid. but i have heard another version that the engine is designed to work at around 90-110 ^c, too low temperature will result in abnormal wearing of the piston..etc

this confuse me a a lot, any other suggestion?
thx ~
作者: vigor    時間: 2008-1-1 10:03
原帖由 henry888 於 2008-1-1 07:43 發表


thx very much bro~
my fd teach me if i want the engine to be durable, i shouldnt lean it during run-in period and just after run-in peroid. but i have heard another version that the engine is des ...


Do not lean the engine during the run-in period as the piston sleeve needs a LOT of LUBRICATION for run-in.  Maintain the run-in temperature at above 80 degrees by setting higher idling speed, rich setting of the engine and reducing heat loss from the heat sink.  

After engine run-in, high engine running temperature (130, 140,...) is not an issue as long as the engine is not excessively lean.  (You can listen to the engine's sound and watch the engine's performance to determine whether the engine is excessively lean)  What you should pay attention is to warm up the engine above the minimum running temperature (around 70 degrees) before running the car  If u run the car agressively with the engine temperature below 70, that can cause excessive wear in the piston sleeve and imposes a lot of stress on the conrod and the crankshaft pin.

[ 本帖最後由 vigor 於 2008-1-1 10:04 編輯 ]
作者: justinwan    時間: 2008-1-1 10:38
你理得佢幾度......佢夠油食.無追油......無死火又夠爆就ok la ......部部engin 個工作溫度都吾同.....吾通你係要放到90 度吾肯行先叫正常?
作者: valklai    時間: 2008-1-1 11:17
原帖由 stanley_wwy 於 2007-12-31 17:40 發表
睇下你用咩engine 同咩pipe 啦....

有d pipe 係會熱少少...

同埋睇你副野run 好未....未溫好又會熱d.

如果你副野係要130度先夠快, 又唔會追油, 又穩定o既話, ...


我部sts D5R working temp. 120度, sts28 working temp. 130c+
If I rich it to 100~110c the engine will back to very slow status.
但我想知咩叫追油呀??
作者: stanley_wwy    時間: 2008-1-2 00:25
原帖由 justinwan 於 2008-1-1 10:38 發表
你理得佢幾度......佢夠油食.無追油......無死火又夠爆就ok la ......部部engin 個工作溫度都吾同.....吾通你係要放到90 度吾肯行先叫正常?



正!
作者: stanley_wwy    時間: 2008-1-2 00:27
原帖由 valklai 於 2008-1-1 11:17 發表


我部sts D5R working temp. 120度, sts28 working temp. 130c+
If I rich it to 100~110c the engine will back to very slow status.
但我想知咩叫追油呀??


行熱咗番黎嘩嘩叫.....好耐或者唔肯去番idle speed.....
作者: valklai    時間: 2008-1-2 09:24
原帖由 stanley_wwy 於 2008-1-2 00:27 發表


行熱咗番黎嘩嘩叫.....好耐或者唔肯去番idle speed.....

哦!!!!!!!!!!!!!!!!!!!!!
作者: lcn    時間: 2008-1-2 12:11
原帖由 stanley_wwy 於 2007-12-31 20:00 發表
12TZ?

咩pipe?


我袈車係孖星RTR單速,唔知乜野pipe.副偈應該係OS.
我用O'donnell 20度油,架車極速都唔係好大藍煙,同溫度有關嗎?
作者: justinwan    時間: 2008-1-2 23:48
校計係睇副計表現.....聽聲睇煙....吾係睇溫度計....
作者: lcn    時間: 2008-1-3 00:31
原帖由 justinwan 於 2008-1-2 23:48 發表
校計係睇副計表現.....聽聲睇煙....吾係睇溫度計....


極速都唔係好大藍煙,正常嗎?同用乜野fuel有關嗎?
作者: 笨仔    時間: 2008-1-3 11:54
[ 答單一問 ]大偈!大偈!我偪os 5port行緊70-80度左右,但係人地覺得我好快,咁係咪唔正常呀偪偈?
另外一撻車就成日死火,行熱咗就冇咁易死火,又點算呀?thx
作者: stanley_wwy    時間: 2008-1-3 14:12
原帖由 笨仔 於 2008-1-3 11:54 發表
[ 答單一問 ]大偈!大偈!我偪os 5port行緊70-80度左右,但係人地覺得我好快,咁係咪唔正常呀偪偈?
另外一撻車就成日死火,行熱咗就冇咁易死火,又點算呀?thx


70-80 度好快??  咁"近"?

係咩場玩呀? 條直路好短架? 唔熱都快?

[ 本帖最後由 stanley_wwy 於 2008-1-3 14:13 編輯 ]
作者: piccoengine    時間: 2008-1-3 14:28
原帖由 笨仔 於 2008-1-3 11:54 發表
[ 答單一問 ]大偈!大偈!我偪os 5port行緊70-80度左右,但係人地覺得我好快,咁係咪唔正常呀偪偈?
另外一撻車就成日死火,行熱咗就冇咁易死火,又點算呀?thx

人地覺得你好快.....
作者: piccoengine    時間: 2008-1-3 14:31
原帖由 笨仔 於 2008-1-3 11:54 發表
[ 答單一問 ]大偈!大偈!我偪os 5port行緊70-80度左右,但係人地覺得我好快,咁係咪唔正常呀偪偈?
另外一撻車就成日死火,行熱咗就冇咁易死火,又點算呀?thx

仲有師兄係咪用人仔殼呀???
作者: stanley_wwy    時間: 2008-1-3 16:18
原帖由 piccoengine 於 2008-1-3 14:31 發表

仲有師兄係咪用人仔殼呀???


咩係人仔殼?
作者: piccoengine    時間: 2008-1-3 16:30
原帖由 stanley_wwy 於 2008-1-3 16:18 發表


咩係人仔殼?

vds.....
對不起,您的帖子小於 10 個字符的限制,請返回修改。
作者: justinwan    時間: 2008-1-3 20:35
原帖由 笨仔 於 2008-1-3 11:54 發表
[ 答單一問 ]大偈!大偈!我偪os 5port行緊70-80度左右,但係人地覺得我好快,咁係咪唔正常呀偪偈?
另外一撻車就成日死火,行熱咗就冇咁易死火,又點算呀?thx


咁姐係仲有得快law ......仲有邊個話你快先?  bertin 定維園ar伯?

一撻車就成日死火,行熱咗就冇咁易死火>>>>換粒火咀先...
作者: chrishkyung    時間: 2008-1-4 12:14
recommend u check check your chicken leg..maybe its the time to change parts




歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://www.rc-evo.com/xbbs/) Powered by Discuz! X3.2