RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: BASIC SET UP CHART FOR AWD [打印本頁]

作者: billy86che    時間: 2007-11-8 17:49
標題: BASIC SET UP CHART FOR AWD
I found this on the net on how to set up a 1/10 Serpent 720:
作者: billy86che    時間: 2007-11-8 18:03
So I made this simplified Chinese version for the AWD:

Hope that is useful.

[ 本帖最後由 billy86che 於 2007-11-9 10:42 編輯 ]
作者: billy86che    時間: 2007-11-8 18:19
有唔妥,一定要插!
作者: DONCENT    時間: 2007-11-9 03:15
其實我都唔太睇得明....
作者: billy86che    時間: 2007-11-9 10:44
原帖由 DONCENT 於 2007-11-9 03:15 發表
其實我都唔太睇得明....


I have a refined version here: (hope it is clearer)

[ 本帖最後由 billy86che 於 2007-11-9 10:58 編輯 ]
作者: billy86che    時間: 2007-11-9 10:56
例子1: 如果你"鬆開油門入彎時轉向不足",根據這個表,第"1"最有效選擇就是更換較軟前胎,第"2"選擇就是選用較軟前彈簧等,如此這般...

明冇?

Point to note: "1" on the chart may not be our 1st choice. It should be the last because it creates the biggest difference. If you have only a slight understeer when off-throttly entering a corner, you should FIRST try to adjust front toe out instead, in order not to make a mess and create problems like oversteer at another corner.

[ 本帖最後由 billy86che 於 2007-11-9 13:04 編輯 ]
作者: 偉記    時間: 2007-11-9 13:10
明哂,唔該哂老師,睇落幫到手,
我一陣去CT試下得唔得
作者: billy86che    時間: 2007-11-9 13:12
Another very important thing: Make sure you fix every part well before you use the chart to start setting up your car.

I have seen too many people asking on how to solve their car's oversteer problem when one or two of the rear wheels were loosely fixed with the lock nuts so they swang during running.
作者: henry888    時間: 2007-11-9 15:06
thank you 老師
SUPPORT~
一陣去試車先
作者: billy86che    時間: 2007-11-11 00:01
Something wrong with the previous. Here is a revised version:
作者: billy86che    時間: 2007-11-11 23:12
改正再改正.
作者: 偉記    時間: 2007-12-4 12:57
各位師兄,經過兩星期反複試驗,
真係幫到手set車
print 番張對住set
睇唔明上到CT問我
唔該 老師




歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://www.rc-evo.com/xbbs/) Powered by Discuz! X3.2