RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: servo 問題? [打印本頁]

作者: hino121 時間: 2007-10-24 12:52
標題: servo 問題?
各位師兄! HS-5929MG servo方咗上部車道玩到义唔多無電就無呔!可以點較?唔該幫忙幫忙!

作者: AMAT 時間: 2007-10-24 13:03
無電就梗係控唔到啦.....差返滿電先講啦......

作者: hino121 時間: 2007-10-24 13:28
但係排電仲好爆! 唔知係唔係電變唔夠出?如果係個接收加Much more電容得唔得呢?

作者: rk2 時間: 2007-10-24 13:40
動力有電, servo 無電 .... ?

作者: AMAT 時間: 2007-10-24 13:46
係咪支控未SET返好呀?

作者: hino121 時間: 2007-10-24 14:01
我唔知呢隻Hitec HS-5929MG servo 係唔係油車用&電車? 試過用M11同3pk都係中尾段乜反應! 唔該晒各位師兄!

作者: AMAT 時間: 2007-10-24 14:03
應該就唔關事.....可能係你SET錯支控O既問題嚟居多......

作者: hino121 時間: 2007-10-24 14:17
師兄;如果3pks點set係唔係ppm/pcm/hrs但我set 咗ppm!唔知點set? 唔該師兄幫忙幫忙

作者: Brushless 時間: 2007-10-24 14:20

原帖由 AMAT 於 2007-10-24 14:03 發表

 登錄/註冊後可看大圖

應該就唔關事.......

should be related to Halloween is coming

作者: Brushless 時間: 2007-10-24 15:24
sorry, just kidding.

you may consider to try the system out with another non-futaba servo, if the probem goes away, then probably the Hitec servo has probem.

3pks is a very smart transimitter and it can automatically change the mode by itself.

Your problem more sounds like a faulty servo which easily overheats(towards the end of the play)

That's the reason why I often discourage people from buying these third party servos. A little bit cheaper, but creates a lot of problems and takes away your fun. It doesn't worth it.

作者: hino121 時間: 2007-10-25 21:45
有冇師兄.....幫到我阿 ! 唔該唔該唔該晒!!

作者: Brushless 時間: 2007-10-25 22:22
結論:請買過過原廠servo。

作者: 笨仔 時間: 2007-10-25 22:27

原帖由 hino121 於 2007-10-24 14:17 發表

 登錄/註冊後可看大圖

師兄;如果3pks點set係唔係ppm/pcm/hrs但我set 咗ppm!唔知點set? 唔該師兄幫忙幫忙

http://www.sendspace.com/file/nijx46

作者: hino121 時間: 2007-10-26 01:22
唔該晒各位師兄! 唔該唔該!

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://www.rc-evo.com/xbbs/)