RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: 點樣先知engine粒bearing係唔得呀???? [打印本頁]

作者: taky    時間: 2007-9-12 02:23
標題: 點樣先知engine粒bearing係唔得呀????
有冇咩方法架???
作者: pug    時間: 2007-9-12 02:32
要拆出黎試,如果死左會cake cake地!我過我勸你一次換晒兩粒,因為要拆多次真係好煩!
作者: vigor    時間: 2007-9-12 07:27
原帖由 taky 於 2007-9-12 02:23 發表
有冇咩方法架???


You may use your finger to rotate the engine bearings.  The bearings must be smooth like new.  It is good that u rotate an entirely new bearing for comparision.  

For some engines, this method is useless as some bearings will suddenly fail even though they seem to be very smooth.  Then u better record the amount of fuel used by the engine.  When certain amount of fuel has been consumed by the engine, you just change the engine bearings, conrod, pin and clips no matter what.
作者: taky    時間: 2007-9-12 12:03
如果我著車時....
架車會有d(鈴鈴)聲.....好似有d野散左咁架....
咁係唔係bearing死左呢???
唔該......
作者: ice1234    時間: 2007-9-12 13:15
拆出黎試lor
作者: vigor    時間: 2007-9-12 19:38
原帖由 taky 於 2007-9-12 12:03 發表
如果我著車時....
架車會有d(鈴鈴)聲.....好似有d野散左咁架....
咁係唔係bearing死左呢???
唔該......


Clutch bearings failure may generate noise.  Clutch bell touching the chassis may also generate noise

[ 本帖最後由 vigor 於 2007-9-12 19:41 編輯 ]




歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://www.rc-evo.com/xbbs/) Powered by Discuz! X3.2