RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: 電變問題 [打印本頁]

作者: TheRC 時間: 2016-7-19 00:23
標題: 電變問題
請問各位師兄呢只電變點設中位？

: 登錄/註冊後可看大圖

作者: ozone 時間: 2016-7-19 07:31
本帖最後由 ozone 於 2016-7-18 15:42 編輯

Sanwa BL-sport

使用電圧	7.2Ｖ	連続最大電流	200Ａ（前進） 100Ａ（後進）
電圧降下		ロス抵抗	0.006Ω（前進） 0.012Ω（後進）

user manual
http://sanwa-denshi.co.jp/rc/car ... F%96%E8%AA%ACB5.pdf

作者: TheRC 時間: 2016-7-20 20:33
師兄呢個睇過但日文睇唔明

作者: 小龍 時間: 2016-7-20 23:13

■Please confirm that a motor connector is not connected.
●I turn on power switch. Please perform it in order of transmitter → speed controller by all means.
(when I turn it off speed controller → transmitter)
●As BL-sport detects the neutral position of the transmitter at the time of power supply injection, please do not operate a transmitter until green LED turns on.
If green LED turns on, please confirm whether an LED checker lamp works like the right figure.
●If adjustment is over, you connect a motor connector, and please prepare for the run.
※When green and red LED turn on in the state that I operated all over the progress side, please set a reverse switch on the transmitter throttle side in reverse (REV).

作者: 小龍 時間: 2016-7-20 23:16

■Operation method of brakes and the next generation (back)
●I am running, and brakes work for the next generation side in proportion to operation in throttle trigger progress when I operate it.
When a given period of time passes with operating it on the brakes side, he/she reverses.
※When there is an endpoint adjust function to the transmitter, I can coordinate the work of brakes in EPA-L. The next generation is not made have weak brakes when I make a set point small.
■Heat protector function
●When the FET of the speed controller generates heat by overload abnormally, I stop the output of the motor.
※When a heat protector function acts, green and the red of the LED checker lamp continue flashing on and off.
■Over current protection function
●When an over current flows by the output short such as motor locks, I turn off FET automatically and protect FET.
※When an over current protection function acts, the LED checker lamp does not turn on

作者: TheRC 時間: 2016-7-22 02:30

ozone 發表於 2016-7-19 07:31
Sanwa BL-sport

user manual

搞掂，唔該師兄。

作者: TheRC 時間: 2016-7-22 02:31

小龍發表於 2016-7-20 23:16
■Operation method of brakes and the next generation (back)
●I am running, and brakes work for th ...

搞掂，唔該小龍兄。

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://www.rc-evo.com/xbbs/)