RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: Kyosho GT clutch and engine question [打印本頁]

作者: hhxhkuroro 時間: 2014-5-10 13:42
標題: Kyosho GT clutch and engine question
c hings which clutch should i be using. i have a rb concept engine.
which clutch is good buku werks or Fioroni ??...
also if i use the rb engine can i still use the factory rear muffler?
thank you

作者: bear_cat_x 時間: 2014-5-10 14:49
For clutch, why don't you use the original ones.
For muffler, if yours are buggy ones then it should probably be ok

作者: hhxhkuroro 時間: 2014-5-12 14:07

bear_cat_x 發表於 2014-5-10 14:49
For clutch, why don't you use the original ones.
For muffler, if yours are buggy ones then it should ...

is the original clutch good? kyosho never have good clutch.. my friend had the old vision of GT2 the sping on the clutch die after run-in

作者: bear_cat_x 時間: 2014-5-12 19:49
is the spring not installed properly for any reason? my v1r uses similar clutch but has no such problems. please note run-in means low rpm. if it breaks after run in, then all similar clutch will break when engine runs.

作者: hhxhkuroro 時間: 2014-5-13 05:43

bear_cat_x 發表於 2014-5-12 19:49
is the spring not installed properly for any reason? my v1r uses similar clutch but has no such prob ...

that gt2 was a RTR vision. thos spring just grinding with the clutch bell which break in.

作者: bear_cat_x 時間: 2014-5-13 08:37
Parts of rtr may not be properly fixed by chance

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://www.rc-evo.com/xbbs/)