RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: Ex-10 AD vs M8 AM vs 3PK AM [打印本頁]

作者: tonytjia@zone 時間: 2006-11-9 23:23
標題: Ex-10 AD vs M8 AM vs 3PK AM
Hi I am new to Mini z and I have a AWD with a few modification.

Currently I am using 2PL and I want to upgrade my 2PL to one of the following:
Ex10
M8
3PK

In term of money Ex10 is the most expensive but I am not sure will it be a lot different from M8 with AM and 3PK with AM?

Any brother can suggest?

best regards,
Tony

作者: soilderman83 時間: 2006-11-10 00:45
The most different is KO EX10 can use AD band but others need to some modifly,if use AD band,On the other hand,If you don't use AD band my suggestion is 3PK

作者: xlarge 時間: 2006-11-10 00:46

原帖由 tonytjia@zone 於 2006-11-9 23:23 發表
Hi I am new to Mini z and I have a AWD with a few modification.

Currently I am using 2PL and I want to upgrade my 2PL to one of the following:
Ex10
M8
3PK

In term of money Ex10 is the most ...

The steering of ad pcb is much smoother than the am pcb
as the ad pcb is product of KO
ex10 is the official product for ad pcb
so it gets the most fast response

作者: pchan0 時間: 2006-11-10 07:19
I run Futaba 3PK with AD band now, I have used Helios before and I think they feel the same as far as speed response is concerned.

作者: cto 時間: 2007-3-30 13:53
標題: 回復 #4 pchan0 的帖子
how to install? $$??

作者: kaho0338 時間: 2007-3-30 14:02
i vote for ex10 with ad brand ........simple question, it have fast response and offical KO product

作者: tonytjia@zone 時間: 2007-3-30 14:32
標題: 回復 #6 kaho0338 的帖子
I finally choose EX-10... I also think Ex-10 is very good and can say better than 3pk and m8

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://www.rc-evo.com/xbbs/)