THX~~~作者: po8082po 時間: 2010-10-14 02:00
如果沒有設定ID碼的話就是 開遙控當顯示屏出現LINK……的字樣，上接收電，等接收機指示燈常亮（如果沒記錯的話應該是紅色），就可以起飛了,不過建議設定ID碼，這樣可以實現1秒對頻，也就是相當於PPM模式http://www.walkera.com/cn/upload/explain/W2801PRO_expc.pdf作者: bbqbbqbbq 時間: 2010-10-14 09:35
thx ching~~~
但係好似無送埋個servo 短路子插.....作者: bbqbbqbbq 時間: 2010-10-14 09:46
我個係細接收 rx2610作者: jf813 時間: 2010-10-14 10:00
2610 do not set the tx to fix id. Just turn on RX (heli) first. Then Turn on the tx. Wait till both Led stop flashing and it should work wor. BTW: can't remeber if you need to set the tx to 2601 mode or 2801 mode......作者: bbqbbqbbq 時間: 2010-10-14 10:04
ching 我對極都對唔到....我無set ID 用RAMDOM作者: jf813 時間: 2010-10-14 10:13
hum...... which mode are your tx set to? I am not sure about 2610 rx. But I think you need to set the tx to 2801 mode if this don't work try 2601 mode.... And check the little antenna on the 4in1 and make sure it is not broken. And what happen to the led on the 4in1, flash slowly or quickly?作者: bbqbbqbbq 時間: 2010-10-14 10:17
flash slowly led blue..............
本身無問題,因為我想自己重新set d野 我就禁左reset....之後就對唔番個接收
個接收係咪清除之前d記憶先可以再對應遙控???作者: jf813 時間: 2010-10-14 10:27
flash slowly there are some issue with your rx wor.... because when you plug in the battery the 4in1 should flash quickly. If the 4in1 bind correctly then it will turn solid red. If it flash slowly mean the rx have lost the receiver signal....作者: bbqbbqbbq 時間: 2010-10-14 10:42
我知道如果對到既話就會好快搞掂~~~
ching 英文我唔係好明.....
暈!!!!
