RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: Sand Scordcher 後令入呔 [打印本頁]

作者: kmart 時間: 2010-4-18 12:32
標題: Sand Scordcher 後令入呔
有無CHING可指教Sand Scorcher條後令點先可容易塞入條呔裡面? (塞到手指頭都爆都未塞得入....

作者: s0301399 時間: 2010-4-18 13:16
回復 1# kmart

查凡士林

作者: gibson 時間: 2010-4-18 15:55
Read the manual, it has shown how to insert the rear rim to the tire!!

作者: peter7 時間: 2010-4-18 16:18
Push it in side way until the wheel is completely inside to tire. Then turn the wheel 90 degree. I can do it in 10 seconds. No lubricant needed.

作者: kmart 時間: 2010-4-18 23:35
I did follow the instruction as per manual: 90 degree penpendicular inside tire and then turn 90 degree. I finally did it but I guess I will take the advice to apply vaseline.

作者: peter7 時間: 2010-4-18 23:46
Don't use vaseline. It is a petroleum product which will damage the tire in long run.

作者: kmart 時間: 2010-4-19 11:53
ok... I guess have to do it by force then...

作者: polarbear 時間: 2010-4-19 11:58
回復 7# kmart
Some soap water or detergent can help.

作者: wingky 時間: 2010-4-19 12:17
SS 條呔未算難入, 照說明書咁做就得, 黃蜂個條釘呔比佢難幾倍....我就將個鈴打棟放在枱面, 然後兩隻手用力拉開條呔, 一野套落個鈴道, 但整完手指勁痛

作者: sinnezm1 時間: 2010-5-21 22:38
依照說明書嘗試了很久都不成功, 請問有無師兄可幫忙, 簿酬. 謝謝.

作者: jas 時間: 2010-5-22 12:19
Try to lube the tire bead with glycerin (甘油). It won't harm the tires.

作者: peter7 時間: 2010-5-22 17:26
no lube needed if you know how.

作者: python 時間: 2010-5-22 22:26
I agree with Peter.

作者: peter7 時間: 2010-5-22 22:55
I give you a hint. You don't just pushing the wheel in the tire. It is more of pulling the tire in the wheel by holding the side of the tire with your thumb and index finger.

作者: sinnezm1 時間: 2010-5-23 20:12
Done it finally. Thanks the advice from all ching.

作者: gibson 時間: 2010-6-26 13:21
本帖最後由 gibson 於 2010-6-26 13:22 編輯

Oh my god, I do have the same problem. I did the frog and buggy champ before, but not SS. I had tried for the whole night, both fingers were so painful.
Bro Peter, when will you go to KWS, I really hope you can help me!!

作者: topedo 時間: 2010-6-27 20:29
I encounter the same problem with you Ching. I still cannot put the tyre on the wheel.

作者: gibson 時間: 2010-6-28 15:25
Finally I did it. It is important to massage the tires first!!

作者: Mobility(雲) 時間: 2010-6-28 15:39
i needed 5 mins for each....
it is sucks.....

作者: Mobility(雲) 時間: 2010-6-28 15:40

Finally I did it. It is important to massage the tires first!!
gibson 發表於 2010-6-28 03:25 PM

登錄/註冊後可看大圖

did you break your fingernails?

作者: gibson 時間: 2010-6-28 15:48
本帖最後由 gibson 於 2010-6-28 15:50 編輯

did you break your fingernails?
Mobility(雲) 發表於 2010-6-28 15:40

登錄/註冊後可看大圖

No, actually after the sucessful of the first one, only took me 30 seconds for the second one!!

If I know that you only need 5 mins, I will pass it to you immediately. This installation totally took me two days to think......

作者: Mobility(雲) 時間: 2010-6-28 16:48

No, actually after the sucessful of the first one, only took me 30 seconds for the second one!! ...
gibson 發表於 2010-6-28 03:48 PM

登錄/註冊後可看大圖

You were sick........

作者: alanwhc 時間: 2010-6-29 11:53
左右拉盡條呔, 然後叫我個靚仔”放” 條後令入去.

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://www.rc-evo.com/xbbs/)