| Configuration (teaching) is required to check each individual transmitter's performance, regardless of the manufacturer. Make sure to perform configuration every time you change the transmitter or use a new transmitter. Below you will be guided through the transmitter teaching mode, please reference your instructions for trim & transmission teaching techniques. |
|
| Set trims to Neutral Turn on transmitter Turn on MFC-02 |
|
Step #1
Hold SW3 button for more than 1 and less than 3 seconds. Hazard lights will flash and engine sound will shut off. Power light and control unit will blink.
|
|
Step #2
Move Left stick from UP to DOWN position
|
|
Step #3
Move Left stick from RIGHT to LEFT position
|
|
Step #4
Move Right stick from UP to DOWN position
|
|
Step #5
Move Right stick from RIGHT to LEFT position
|
|
Step #6
Push SW3 button and engine sound will start up. |
|
Troubleshooting
If the above did not work and controls are not set correctly follow the below instructions to reset the MFC-02 and try above steps again.
Reset to Defaults - Turn off the MFC-02
- Turn on MFC-02 while holding down SW3 button
- All settings with return to defaults
|
