標題: My esky lama v4 is.............. [打印本頁] 作者: ~CCXR~ 時間: 2009-7-27 15:20 標題: My esky lama v4 is.............. i just bought a lama v4
but after playing for awhile
the heli start to smoked out
then the whole heli didn;t move
i've check the second motor had burned
but dun know why even the servo don't work also?
咩no 我忙了,作者: ~CCXR~ 時間: 2009-7-27 17:36
what is BEC?作者: zifu 時間: 2009-7-27 22:30
no, burn receiver作者: ~CCXR~ 時間: 2009-7-27 23:29
u mean the receiver(with the gyro and esc inside that one??)作者: 小步 時間: 2009-7-27 23:45
It has to mainboard combine
One is receiver and one is 3in1 controller
If just burn the ESC is easy to repair ,just replace new IRF-7403 MOS-FET IC is OK
Receiver is hard to burn out coz It accept 3.6V to 12V directly
Coz Receiver need power supply fm 3in1 controller , so if the BEC IC burn then all electronic out of power .
Its not only your case , Its common in ESKY 4in1 esp in LAMA作者: zifu 時間: 2009-7-28 01:17
yes, 4in1作者: zifu 時間: 2009-7-28 01:18
servos not work作者: ~CCXR~ 時間: 2009-7-28 15:01
so if i want to change other esc
which one is better
ps:just about 300-400 is fine作者: 小步 時間: 2009-7-28 17:02
buy a new lama only $400 or below $400
It can be repair only cost $1 by DIY =.=//作者: ~CCXR~ 時間: 2009-7-28 20:47
how???????