標題: Durango DEX-410 Open Box and Building Report [打印本頁] 作者: joho 時間: 2009-6-29 12:25 標題: Durango DEX-410 Open Box and Building Report 本帖最後由 joho 於 2009-6-29 12:26 編輯
Please note, the following sample are pre-production sample only, the release version may be different.
Well, a family re-union, on the right is my trusted D4, one of the best car I ever driven. On the left is the new Durango, without manual since it's not finalize yet.
[attach]274330[/attach]
Let's take a look on the body first. My first impression was: SLIM! I have never seen somthing like this narrow before.
Compare with the D4 Body
[attach]274331[/attach]
Compare with B4 and D4.
[attach]274332[/attach]
A big rear wing, nicely made I must say.
[attach]274333[/attach]
Wheels are using the now standard "Losi" pattern, with a small hex type in the front and "pin" type at the rear.
[attach]274334[/attach]
[attach]274335[/attach]
[attach]274336[/attach]
Due to the fact this is only a sample, all plastic parts are in one single big bag,
[attach]274337[/attach]
You can found the "Team Durango" logos on some of them. The scratchs are caused by chucking everything into one bag...
[attach]274338[/attach]
[attach]274339[/attach]作者: raman9551 時間: 2009-6-29 12:46 好型喎作者: hardmankam 時間: 2009-6-29 12:48
car looks promising! keep us updated.作者: tiger1 時間: 2009-6-29 12:55
ha ha, more lah 作者: joho 時間: 2009-6-29 13:04
Thank you for the kind words, so here we go!
I am starting with the Center sliper assembly first.
These are all the parts needed for the build:
[attach]274349[/attach]
As you can see, the main shaft, which contain one side of the slipper, were lightened everywhere...
[attach]274350[/attach]
[attach]274351[/attach]
A very typical "Asso" shaped slipper pad, however, I am not sure what material they are, never seen somthing like this before. Also, it is quite thick and grippy.
[attach]274352[/attach]
The car came with a 87T Spur, even the spur itself are lightened...crazy..
[attach]274353[/attach]
With the Spur fitted.
[attach]274354[/attach]
The other side of the slipper plate. Again, I lost count how many hole they have drill! It was hard anodize too.
[attach]274355[/attach]
[attach]274356[/attach]
The spring cup holder had a very welcome feature, with a lock nut, the chances of it get losen under load will be minimal.
[attach]274357[/attach]
Again, crazy light out drive cup..
[attach]274358[/attach]
The complete slipper.
[attach]274359[/attach]
[attach]274360[/attach]
[attach]274361[/attach]
A comparison with the D4 slipper set, Durango on top, and D4 at the bottom. As you can tell, the Durango item were physically smaller, and by all means, alot lighter...You can easily tell when you are holding them.
[attach]274362[/attach]
好型喎