RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: [求助]Art tech只predator點轉receiver? [打印本頁]

作者: Akito 時間: 2009-5-30 17:34
標題: [求助]Art tech只predator點轉receiver?
如圖所示,架機得兩個servo,V tail機,兩個控制面only.
有趣既係得一舊9.6v電池供電,經電變比電receiver同時有接收信號控制motor.
我用只fataba receiver,插channel 2&4 set v-tail無問題.
但係就控制唔倒個motor,無反應......
應該點做?
多謝解答~!

: 登錄/註冊後可看大圖

作者: Andrew168 時間: 2009-5-30 18:29
測試 ch3 , ch3插上 servo, 動作是否正常, 如不正常, ch3 可能有問題
否則 esc 可能出問題, 睇 esc manual set 油門高低點

作者: raptor50x 時間: 2009-5-30 18:51
Use Channel 3.

Like Andrew168 said, if still not working, try reverse Channel 3 in the Tx.

作者: 小步 時間: 2009-5-30 20:05
Default CH3 is1 FUTABA Thuttle
Try CH3 for your ESC Connection , If thuttle RANGE IS OVER TRY GIVE 100% THUTTLE and connect the battary the lowest the thuttle again to set the Thuttle range

作者: Akito 時間: 2009-5-30 20:31
用servo試過channel3無問題.

ESC係指mud野?
全稱係......

作者: coltm16 時間: 2009-5-30 21:39
electric supple control

作者: Akito 時間: 2009-5-30 21:53

electric supple control
coltm16 發表於 2009-5-30 21:39

登錄/註冊後可看大圖

成本manual search唔倒有electric supply control呢只字眼

作者: Akito 時間: 2009-5-30 22:10
可以較得既係曬度......
邊個搞throttle?

: 登錄/註冊後可看大圖

作者: zifu 時間: 2009-5-30 22:44
等高手答完先

作者: zifu 時間: 2009-6-1 22:48
都無人答,我只是唔識想學野

作者: jf813 時間: 2009-6-5 18:29
本帖最後由 jf813 於 2009-6-5 18:35 編輯

ESC = electronic speed controller (電變). EPA- ch3, push throttle stick up and set it to 100%, then push it to lowest postion and set it to 100% again. sorry don't have art tech so not sure how to set it up..... Is it right zifu?

作者: zifu 時間: 2009-6-5 23:18
hi throttle timer high
low throttle timer low
and after than set middle

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://www.rc-evo.com/xbbs/)