我想問下2801PRO 點對應番個接收架???HELP~~~~PLZ~~~~

各位CHING唔該幫幫忙

THX~~~

如果沒有設定ID碼的話就是   開遙控當顯示屏出現LINK……的字樣，上接收電，等接收機指示燈常亮（如果沒記錯的話應該是紅色），就可以起飛了,不過建議設定ID碼，這樣可以實現1秒對頻，也就是相當於PPM模式http://www.walkera.com/cn/upload/explain/W2801PRO_expc.pdf

thx   ching~~~
但係好似無送埋個servo 短路子插.....

我個係細接收  rx2610

2610 do not set the tx to fix id.  Just turn on RX (heli) first.  Then Turn on the tx.  Wait till both Led stop flashing and it should work wor.  BTW:  can't remeber if you need to set the tx to 2601 mode or 2801 mode......

ching  我對極都對唔到....我無set ID  用RAMDOM

hum......  which mode are your tx set to?  I am not sure about 2610 rx.  But I think you need to set the tx to 2801 mode if this don't work try 2601 mode....  And check the little antenna on the 4in1 and make sure it is not broken.  And what happen to the led on the 4in1, flash slowly or quickly?

flash slowly led blue..............
本身無問題,因為我想自己重新set d野 我就禁左reset....之後就對唔番個接收

個接收係咪清除之前d記憶先可以再對應遙控???

flash slowly there are some issue with your rx wor....  because when you plug in the battery the 4in1 should flash quickly.  If the 4in1 bind correctly then it will turn solid red.  If it flash slowly mean the rx have lost the receiver signal....

我知道如果對到既話就會好快搞掂~~~
ching  英文我唔係好明.....

係呢個接收

用獲記玩留自己機仔唔洗對頻!插電開控即可

感謝jf813  呢位熱心既師兄幫忙!

回復 11# touch-9


    tthx~~~問題已搞掂...
唔係直接對就得.....

要set 番做2601....先得

暈!!!!