水冷無水出

各位師兄,

我部船的水冷無水出,各位師兄可否指點我如何解決,現附相作參考.

師兄，愚見，似乎個入水太直同位置要修改下...

可参考這裏 http://www.jet-drive.de/cms/content/view/41/25/lang,en/

I 'll let you know after I test

kyosho D 船成日都係咁,水泠管入水位去唔到車葉位
可以DIY加支短銅管仔cut斜佢like me!!!(my ship is kyosho airsteam)

I extended a3mm long and I tested it in my bath, It seems OK! so Happy, Thank you for your advise....

I will go & try this week!

With photo,

原帖由 ChinaBilly 於 2009-2-26 22:36 發表

                               
登錄/註冊後可看大圖

I extended a3mm long and I tested it in my bath, It seems OK! so Happy, Thank you for your advise....

I will go & try this week!

If u use plastic tube to extend it. I'm worry when the motor full power,the tube will bend woo..
I suggust use a large size of copper tube and use yr way to plug-in will much better!!!

I tested this Sat. U r right again, when full power the water output  is less (slower is better), I will change the copper tube instead. (What size?)

By the way, The speed is getting slower after 3 to 5 times of full power, is that the cooling system problems or Motor issues?

Can you help again?

I am using the hobbywing  9T motor, 60A water cooling Esc and 7.4V 5000mah Lipo battery

原帖由 ChinaBilly 於 2009-3-2 09:41 發表

                               
登錄/註冊後可看大圖

I tested this Sat. U r right again, when full power the water output  is less (slower is better), I will change the copper tube instead. (What size?)

By the way, The speed is getting slower after 3 ...

For the copper tube, its depends on your boat. Just buy one the inner dia. can plug-in is okay.
For my boat's water inlet point dia. is 5mm.
I don't know the problem about the electronic, coz I just play GP boat. Sorry!!!!
But I'll hv a EP boat will a assembly later, I also want to know yr problem too...

Thanks anyway!

原帖由 ChinaBilly 於 2009-2-26 22:36 發表

                               
登錄/註冊後可看大圖

I extended a3mm long and I tested it in my bath, It seems OK! so Happy, Thank you for your advise....

I will go & try this week!

thanks brother of the water inlet point ideal.
I've modify my inlet point as follow:-

Any improvement?

I havn't try it.....
will tell u later!!