so ... I HOPE i won't crash HARD
people don't crash me please hahaahah
by the way
I don't think my car will Run well too ... but I just want to Build it ... everything is AFTER WORD ...
kaidogg 發表於 2009-9-16 21:15
[quote]
yes yes you already helped me alot
for my Future car
this Prototype car have problem already hahaahaah
I just found out .... the SERVO holder is in the wrong place .... hahahahaahahahahahaahaha ...
u r already very strong, can DIY a car, add oil la, remember to show us photo wor
yes yes you already helped me alot
for my Future car
this Prototype car have problem already hahaahaah
I just found out .... the SERVO holder is in the wrong place .... hahahahaahahahahahaahahaaha
cannot la T_T
I have limited skills
一係WELD 一係全車 SCREWS AND NUTS
BUT ...... using aluminium alloy plates is hard to get the shape of what I want
anyway let me finish this car ... if it's really that suck as you said it would be ... then I start new project haha
and put this car into my 貢品 區
but most important is ... you give me very good suggestion
thanks thanks thanks
it will be better.
you idea is good, but better for choosing the material.
i think use 2-3 mm thick aluminium alloy will better
also, 4mm steel bar to make the chassis will be the best.
deadmatch 發表於 2009-9-16 21:19
it will be better.
you idea is good, but better for choosing the material.
i think use 2-3 mm thick aluminium alloy will better
also, 4mm steel bar to make the chassis will be the best.
once damping in the solid rear axial, the 4-link system will cause a angle bending in the solid rear axial. that will cause a little effect on the straight motion of the RC
deadmatch 發表於 2009-9-16 20:58
but if you install Roll Bar system it will be ok ?
so ... I HOPE i won't crash HARD
people don't crash me please hahaahah
by the way
I don't think my car will Run well too ... but I just want to Build it ... everything is AFTER WORDS
hahaahahah
you know that the sudden impact is much much bigger .....
i know your car is base on the real car. but for a real car , when it crash, it will collapse also.....
but for RC don't.......
by the way
my car is based on this real truck
so ... should be strong enough
I tried to THROW my cage out the windows and is ok wor
I live in 1st floow
once damping in the solid rear axial, the 4-link system will cause a angle bending in the solid rear axial. that will cause a little effect on the straight motion of the RC
deadmatch 發表於 2009-9-16 20:58