標題: 請問Half 8 Mini Inferno用Trinity Monster Termination motor [打印本頁] 作者: pgm250 時間: 2007-9-28 15:09 標題: 請問Half 8 Mini Inferno用Trinity Monster Termination motor 請問Half 8 Mini Inferno(行9.6v)用Trinity Monster Termination motor快唔快?同原裝motor差幾多?~~THX~~
Monster Termination TRI11995
22 Turns - Short Can
• New wind for more speed & power than stock motor
• Adjustable Timing
• Changeable brushes and springs
• No radio glitching
• Stronger magnets for more torque.
*** HIGHEST RPM OF ALL MINI MOTORS! ***
- Suggested Gearing: 9 tooth pinion
Length: 1.25" (32mm) not including shaft
Can diameter: .95" (24mm)
Shaft diameter: .077" (2mm) shaft is knurled
作者: looseman 時間: 2008-2-2 17:05
i suggest you should USE brushless motor + lipo 7.4~11.1v 2-3 cells la~
mini inf is too heavy, needs to use a smaller pinion, 5~6.8Kv should be ok fast enough, 8kv+ needs to mod alot for smooth safety run!
very depends on how much u r willing to pay for upgrades? only upgraded a fast brushed motor, i'm sure it is gonna be died sooo quick. never just upgrade a fast motor without upgrade other important parts. A short life time repleacements may cost u more than some modding.
if u r playing on the cheap way, try these china made lipo, and brushless ESC + motor, totally value is cheaper than a Trinity motor, and you should think it is worth with good C/P.
