RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: v1s3 can't run in a straight line [打印本頁]

作者: ng222 時間: 2006-10-18 23:27
標題: v1s3 can't run in a straight line
wht can i set to the car
the angle is large and turn to left side ><
there is no use tune in controller

作者: rsx 時間: 2006-10-19 00:11
This is a very good link, hope it can help you.

http://bbs.rc-evo.com/forumdisplay.php?fid=43

作者: rsx 時間: 2006-10-19 00:12
It is worth your time to read and read the message again and again.

作者: ng222 時間: 2006-10-19 00:43
i am a new hand

which topic is right?

[ 本帖最後由 ng222 於 2006-10-19 00:48 編輯 ]

作者: 毒魚 時間: 2006-10-19 01:09
http://bbs.rc-evo.com/viewthread.php?tid=1921&extra=page%3D1

作者: ng222 時間: 2006-10-19 23:26
i read the post b4
but i still cannot set it to a straight forward movement
please help

[ 本帖最後由 ng222 於 2006-10-20 09:47 編輯 ]

作者: rsx 時間: 2006-10-20 09:21
The last image is strange, the servo should be in centre position !?
I would suggest to check the fron wheel alignment and then the rear wheel alignment.
First make sure they are all straight.

作者: rsx 時間: 2006-10-20 09:22
There is a image showing the carb in idle position. Is this a stock engine from the v1s ? My guess is the carb opening is too narrow. (which cause idle and starting problem)

作者: ng222 時間: 2006-10-20 09:45

原帖由 rsx 於 2006-10-20 09:22 發表
There is a image showing the carb in idle position. Is this a stock engine from the v1s ? My guess is the carb opening is too narrow. (which cause idle and starting problem)

HOW CAN I MAKE THE IDLE POSITION MORE SPACE(NOT NARROW)??

作者: rsx 時間: 2006-10-20 09:52
THERE IS A SCREW TO ADJUST,

READ MANUAL

作者: 毒魚 時間: 2006-10-20 11:49
你低速氣門太細了,上面有支打斜的螺絲可以調整他大細的,

大油針又好像太多......將他扭入去再扭3圏出來試試

作者: ftbingobingo 時間: 2006-10-20 16:45
條尾呔係咪有問題?

作者: ng222 時間: 2006-10-20 22:53

原帖由 ftbingobingo 於 2006-10-20 16:45 發表
條尾呔係咪有問題?

how check?

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://www.rc-evo.com/xbbs/)