RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: 新手第一次玩油車,買了車,入了油,但... [打印本頁]

作者: 煋人    時間: 2012-3-22 22:33
標題: 新手第一次玩油車,買了車,入了油,但...
開不到車,不太識用火咀
作者: 煋人    時間: 2012-3-22 22:37
火咀有的
有無師兄師姐
幫下小弟
作者: @肥基@    時間: 2012-3-22 23:02
火咀有冇插電呀
作者: rico    時間: 2012-3-22 23:23
唔識睇下付近有無師兄幫下你。
作者: asaq-wong    時間: 2012-3-22 23:37
邊區呀? 樓主~
作者: asaq-wong    時間: 2012-3-22 23:39
手撻定電撻? 乜野車?
作者: pkogps    時間: 2012-3-22 23:43
師兄買了邊款?
作者: bear_cat_x    時間: 2012-3-23 08:33
回復 煋人 的帖子

ching,
1. put fuel into fuel tank
2. plug the exhaust outlet by using finger or toilet paper
3. pull the engine repeatedly until fuel is going into the engine
4. remove the plug mentioned in 2. above
5. put the glow starter on the "dick" at the heat sink. (do you know how to put?)
6. pull the engine. if fuel has already get into engine and glow starter has been installed properly, you can smell burnt fuel. it means the engine tends to start. give it few more pulls, it will then start!
作者: bear_cat_x    時間: 2012-3-23 08:35
回復 煋人 的帖子

ching, after you have started your car properly, can we play together sin?
作者: cedricho    時間: 2012-3-23 12:25
回復 煋人 的帖子

咩區?
作者: bear_cat_x    時間: 2012-3-23 13:00
tsing yi?
作者: 煋人    時間: 2012-3-23 23:55
上水,弄了一天
着了車,但又很快熄了
和如果 我玩完了,不知如何才可熄車呢?
作者: rcworldhk    時間: 2012-3-23 23:58
煋人 發表於 2012-3-23 23:55
上水,弄了一天
着了車,但又很快熄了
和如果 我玩完了,不知如何才可熄車呢?

去PYC請教各位ching
作者: bear_cat_x    時間: 2012-3-24 08:42
回復 煋人 的帖子

to shut down the engine, you can:
1. squeeze the fuel inlet; or
2. plug the air inlet; or
3. plug the exhaust outlet.
there may be many possibilities that your engine stops immediately after it started. even low battery level of the glow started is also a reason. properly charge your glow starter and retry. if problem subsists, try to adjust the main needle by using following stupid but sure method:
1. rotate the needle by 180 degree clockwise;
2. make sure fuel has got into engine;
3. install glow starter and pull start;
4. if not ok, then remove glow starter and rotate the needle anticlockwise by 180+180 and then 2, 3. if not ok, then remove glow starter and rotate the needle clockwise 180+180+180 and then 2, 3. if not ok, remove glow starter and rotate the needle anticlosewise 180+180+180+180 and then 2, 3... and so on until the engine starts properly.
作者: kay1926    時間: 2012-3-24 09:10
C HING 是不是住上水,明天來粉嶺火車站我幫你 SET - SET ,大家研究下,你玩 OFF ROAD ,  定 ON ROAD

作者: DOG007    時間: 2012-4-3 22:55
入場玩啦...我以前都係入場得到好多熱心既師兄幫手
作者: jack326    時間: 2012-5-8 21:30
新手報到




歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://www.rc-evo.com/xbbs/) Powered by Discuz! X3.2