RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: updated OS engine v-one RRR problems. please help [打印本頁]

作者: hhxhkuroro 時間: 2010-10-22 17:43
標題: updated OS engine v-one RRR problems. please help
本帖最後由 hhxhkuroro 於 2010-10-23 17:38 編輯

ching i bought a used OS max 12tz engine with a v-one rrr but on the engine i don't know the factory setting. any body know that can tell me the needle setting for OS engine. i have 3 needles and a idle screw in Carburetor 化油器.

我是新來的手。我不想使用昂貴的引擎。這種發動機是v-one rrr 可用的...... Ofna Jammin .12
http://www.amainhobbies.com/prod ... n-Pull-Start-Engine

作者: Fluke 時間: 2010-10-22 22:50
本帖最後由 Fluke 於 2010-10-22 22:51 編輯

http://www.osengines.com/manuals/index.html

click 12TZ
page 18~20

作者: hhxhkuroro 時間: 2010-10-23 01:30
回復 2# Fluke

ching i found that already... but that doesn't say how many turn is the screw........ it only say flat to the body,.

作者: hhxhkuroro 時間: 2010-10-23 17:41
help please.....

作者: beebone 時間: 2010-10-25 08:14
Run and check the temperature, just ignore about the factory setting because AFM is too rich.

作者: r003 時間: 2010-10-25 14:23
High Speed Needle (HSN) 2 turns out from closed.

Low Speed Needle (LSN) close it fully (with carb open, so as not to damage the main jet), teh open it until it is flush with the slide body.

Main Jet Needle or Valve (MRN) has to be flush with carburator body, and leave it there and never touch it again.

Idle Speed Needle (ISN), close it until slide valve is open about 1mm, and then when engine has started and warmed enough readjust to a slow steady idle.

作者: ul8000kbs 時間: 2010-10-26 01:13
如果真係set到亂晒搞唔掂咪落kws刺激消費囉.............

作者: Fluke 時間: 2010-10-26 18:39

High Speed Needle (HSN) 2 turns out from closed.

Low Speed Needle (LSN) close it fully (with carb ...
r003 發表於 2010-10-25 14:23

登錄/註冊後可看大圖

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://www.rc-evo.com/xbbs/)