Servo Problem for M CAR

Servo TowerPro MG995 can use for M-car?

inch123456 發表於 2011-6-2 09:43

                               
登錄/註冊後可看大圖

Servo TowerPro MG995 can use for M-car?

can use

Thanks...

My M-CAR got a problem last night.
I am using orginal esc+motor+ MG995+ GTB3.
Case 1) When everything is connected, the car is out of control.
e.g.  if turn left or right then the motor run
Case 2) only connect motor, no servo
The car can go and back correctly
Case 3) no motor but servo
The car cannot turn left or right correclty

Any ideas? it is setting problem or the parts problem?

I am thinking this problem is related with servo.

Thanks

if turn left or right then the motor run
應該CHANNEL插錯左

inch123456 發表於 2011-6-2 11:38

                               
登錄/註冊後可看大圖

Thanks...

My M-CAR got a problem last night.

試下掉轉CH1同CH2個插頭，同埋留意下有冇反轉左上下來插

回復 zivtong 的帖子

thanks...

at the beginning....everything is okay...work correctly....but play for a while ..it goes wrong...

inch123456 發表於 2011-6-2 13:38

                               
登錄/註冊後可看大圖

回復 zivtong 的帖子

thanks...

then maybe problem of the receiver

回復 edwardchow1 的帖子

yes...i tried...
first...ch1 for servo, ch2 for motor...

then i change the ch2 for servo...it can not work......
and i change the ch1 for motor...it can go when i turn left...but turn right, can not go back...

thanks

回復 edwardchow1 的帖子

for Case 2) only connect motor, no servo
The car can go and back correctly...

it may servo problem....

now dont know what should buy to check

inch123456 發表於 2011-6-2 13:42

                               
登錄/註冊後可看大圖

回復 edwardchow1 的帖子

for Case 2) only connect motor, no servo

if you think it is problem of servo, then buy a new servo is fine

回復 edwardchow1 的帖子

thanks.....me really dont know....